0
Where is the temperature sending unit located on a 1985 fiero 2.8 v6?
Wiki User
∙ 12y ago
There are two:
Gauge and light:This sender is on the rear of the rear cylinder head toward the drivers side of the car. Sort of below the coil. Cooling fan control:This is a pain. It lives threaded into the intake manifold at the base of the thermostat housing, it has a single wire connector that pushes into it from the top.Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
What is the Normal operating temperature for a 1985 Pontiac fiero?
About 185F.
On a 1985 F150 Ford truck 300 cubic inc engine where is the sending unit for the temperature gauge located?
The temperature sending unit for this truck is located in the cylinder head on the right hand side at the very back (right behind the exhaust outlet for #6 cylinder)...... you out ...........
Does a 1985 Pontiac fiero 4 cylinder trans fit in a 1985 v6 Pontiac fiero?
Yes, sort of, The clutch is different.
Is a 1988 fiero wiring harness compatible with a 1985 fiero computer?
No the 1988 underwent a big upgrade
Where is the sending unit for the engine temperature gauge located on a 1985 Ford Mustang LX?
its located on the block on the drivers side just above the valve cover behind the a/c compressor and has a capped wire end attached to it.
What bolt pattern is the 1985 Fiero Sport Coupe?
5x100mm
What is the Recommended oil weight for 1985 v6 fiero?
5w30
9 Location of oil temperature sending unit for a 350 1985 corvette?
It is right behind the distributor. IT is HARD to get to.
What is 1985 Pontiac fiero worth?
for me there is no money it how much you love your car
How much did a 1985 Pontiac Fiero cost brand new?
about 10k
What is the stock horsepower of a 1985 Pontiac Fiero?
what is the smog and vaccum diagram for the 87 Pontiac fiero 2.5L 4 cylinder what is the smog and vaccum diagram for the 87 Pontiac fiero 2.5L 4 cylinder
Why wouldn't a water pump from a 1985 Fiero 2.8 V6 fit a 1987 Fiero 2.8 V6?
My Fiero parts supplier, The Fiero Store, only lists one pump so unless a 3.4 crate motor was put ( I did this to mine ) in they will interchange.
