Want this question answered?
the car has the original alternator in it, the brackets for the new alternator (the ford one) are uneven and wont fit the belts on them, i was wondering if i can take the brackets from the old alternator and replace them on the for so the belts will fit answer quickly thanks!
i am trying to replace the belt tensioner on my 1997 ls400 , i got everything loose but there is a plastic seal right in front of it , it is holding the tensioner and there is where i got stuck , can someone tell me how to get the tensioner out without removing the plastic seal . thanks
hallo how need replace alternator belt and tensionier on peugeot 307 hdi manual?thanks
Could you be more informative?Which engine is in it?Thanks
I own a 98 3000 gt base model. Its actually easier than I thought. There is a "Jackscrew Tensioner" near by the alternator, right where the you place the serpentine belt. You will notice a pulley that connects to the "JAckscrew Tensioner" You must only LOOSEN that bolt that goes INTO that pulley. Afterwards, loosen the JAckscrew Tensioner. The Pulley should move freeley forwards and backwards. At that point, you can place the serpentine belt over the Crankshaft, alternator and over the pulley. Tighten the Tensioner until the belt is secure over the THREE different Pulleys (crank shaft pulley, alternator pulley and the top tension pulley. Check the tension of the belt by Twisting it. It should twist no more and no less than half a turn. If you have more or less, you need to adjust the Jackscrew more. AFter you are done. Re tighten the BOLT that goes INTO the Tention Pulley. Run the engine, inspect the belt, listen for sounds and things like that. Im no mechanic, but this was super easy actually. Look up the belt diagram online. 3sx.org is a good site for 3000gt and dodge stealths. Thanks, Alex A.
Remove front exhaust pipe and drop it out.
How do you replace the water pump for a 1998 vw golf? What are the procedurs? Thanks Ro Euraoba rogason@yahoo.ca
Please email me a photo of where the blower motor resistor is and how to change it. Thanks, Michael. By the way I want it for a 2000 Sunfire not a Grand Am.
it is spring loaded there is no release it has to be held long handle ratchet Thanks car is good to go
Looking at the front of the engine, on the left hand side at the top is the power steering pump. Directly below that is the alternator and directly below the alternator is the compressor. AEasiest to get to from below.
Approximately 85 percent of the parts of the 1998 Chevrolet Cavalier and the 1998 Pontiac sun fire are interchangeable. Most of the parts that are not interchangeable are in the passenger compartment.
i had this same problem. it was faulty wiring underneath the battery.