1992 Chevy trucks did not have a CAM SENSOR. They had a distributor.
The crankshaft sensor is located in the engine on a Chevy 1500 truck. This is under the hood.
The PCV valve on a 1992 Chevy 1500 350 is located on the intake manifold which is on the passenger side of the vehicle and to the right of the throttle. It has two bolts that hold it in place.
1992 Chevy 1500
where is the thermostat located in a 1992 cutless supreme automobile
what size rims are on a 1992 chevy 1500 w/t truck
Usually in housing at engine end of upper radiator hose
Remove the water supply hose from your 1992 Chevy thermostat housing. Remove the thermostat housing retaining bolts. The thermostat can be lifted out. Reverse the process to install the new thermostat.
The 1992 Chevy 3500 temperature sensor is located on the front of the engine. The temperature sensor will be in the vicinity of the thermostat housing.
Where is the thermostat located and how do you replace it on 1992 toyota camry 4 cylinder ingine
The 1992 Chevy K 1500 speed sensor is located on the back of the transmission. The speed sensor will be in the upper right-hand corner of the transmission.
What is the cost for 1992 thermostat
The thermostat in a 1992 Honda Accord is found in the thermostat housing. The thermostat housing can be found by following the lower radiator hose.
Yes it does, Rear ONLY.
No there is not.
Follow the lower radiator hose from the radiator to the thermostat.
i need rear break digram for my Chevy 1500 k pick up where can i find it.
tranny should be a 700r4
see where the top hose is ? trace it down to where the motor is and you just found it Good luck PS its not as bad as it looks
The thermostat in a 1992 Honda accord lx is located in housing that can be found when you follow the upper radiator hose back and finding where it connects to the engine.
1992 Lexus es300 wear the thermostat is located
Drain the water from the cooling system of your 1992 Saturn. Remove the water hose. Remove the thermostat housing retaining bolts. Take the thermostat out. Reverse the process to install the new thermostat.