answersLogoWhite
Ford Ranger
Ford Ranger XL
Ford Ranger XLT

Where is the thermostat located on a 1993 Ford Ranger XL?

545556

Top Answer
User Avatar
Wiki User
Answered 2010-03-03 06:37:15

Follow the upper radiator hose to the engine. The spigot that the hose attaches to should have 2 bolts holding it to the engine block. The thermostat should be located under that spigot.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Your Answer

Related Questions




Just follow the top radiator hose from the radiator . It connects to a metal pipe which is part of the thermostat housing that is bolted to the front of the engine . The engine thermostat is inside the thermostat housing


If it is the same as a 1993 Ford Explorer it is in the interior fuse panel


There is supposed to be an engine thermostat . Do you mean that someone has removed the engine thermostat ? What year of Ford Ranger and what year ?


follow the top radiator hose to the engine, the thermostat is located in the housing that that end of the hose is connected to


The thermostat on a 1993 Ford e 350 7.3 diesel is located on the side of the engine. The thermostat can be found by following the upper radiator hose.


can you use a transmission from a 1993 ford ranger in a 2000 ford ranger?


follow the top radiator hose to the engine, remove it then remove the thermostat housing, remove the thermostat and replace it


where is location of thermostat in ford aerostar van, 1993


how to i change a clutch in a 1993 ford ranger


follow the top radiator hose to the motor the hose is clamped to the thermostat housing remove the housing and you will find your thermostat


On a 1993 Ford F-150 : Follow the top radiator hose from the radiator . Where it connects to the engine is the engine cooling thermostat



The thermostat is done it has to be replaced.......


The computer on a 1993 Ford Ranger is located in the dash in the center just above the transmission hump. The computer is located just below the heater control panel.



The low pressure port on a 1993 Ford Ranger is located close to the firewall. It can be seen just under the air filter housing.


The 1992 Ford Ranger 4.0 liter had a 197 * Fahrenheit thermostat from the factory


The 1993 Ford Ranger does not have an alarm override but. You can override the alarm system by removing the alarm system fuse.


On a 1995 Ford Ranger : I know on the 4.0 liter EFI engine , you follow the top radiator hose from the radiator . It connects to a metal pipe which is part of the engine cooling thermostat housing that is bolted to the front of the engine . The thermostat is inside the housing


where is the thermostat located on a 1989 ford tempo


follow the lower radiator hose,it will connect to the pump.you may have a thermostat mounted to the pump and your pump may be fine, check this out first.


It is located between the distributor at the back or the engine.


The engines in a 1993 Ford Ranger are fuel injected , so there is no carburetor



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.