Want this question answered?
Timing connector is located rightside passenger floor where the carpet meets the firewall inside
separate a timing connector on the firewall in engine bay which allows you to time the engine,then adjust the distributor.The connector is on the drivers side below the cowl and when separated the engine will run differently.
The timing mark on a Chevy Inline 6 engine is located on the flywheel. It is a steel ball. The timing needs to?æbe located at 4 degrees BTDC.
To set the timing on a 1984 Chevy Celebrity with the V6 engine: 1. Disconnect the HEI connector so the engine will run in closed loop. 2. Start the engine and use an inductive timing light to check the timing. It should be at 100 before top dead center 3. If the timing is off loosen the clamp at the base of the distributor and turn the distributor so that the timing is set. 4. When you have set the timing tighten the clamp and verify that the timing did not change. If it stayed the same reconnect the HEI connector.
in the engine block
The crank position sensor On your astro is located on front of the engine on timing cover, left side. Behind the crankshaft pulley. with a connector of 3 wires.
It does not have one. The timing is controlled by the computer. You must have a OBDII engine scanner to adjust the timing. If you did not have the distributor out are move it then there is no reason to adjust the timing. It is done automatically by the computer.
The 1987 Chevrolet Nova timing belt is located on the front of the engine. You will need to remove the engine cover in order to see the timing belt.
The timing chain is located on the left side of the engine, to access it you will need to take off the manifold cover.
That year did not have one because the timing is computer controlled and can be only adjusted with a Engine SCANNER.
what is the ignition timing for a 1988 Chevy 454 engine
I may not be 100% correct but i believe its on the base of the distributor