Behind the engine, on the passenger side, just in front of the firewall.
The transmission dipstick for the 1991 Chevrolet Caprice is located on the side of the transmission. It will be behind a valve cover.
there is not a dipstick on a manual transmission
If it is an Automatic just open the hood and look down at where the transmission bolts to the engine. There you will see the dipstick.
The automatic transmission is an A4LD in a 1991 Ford Explorer
On a 1991 Ford Explorer : The A4LD automatic transmission uses MERCON automatic transmission fluid according to my Haynes Ford Explorer repair manual * the type of fluid used should be engraved into the automatic transmission fluid level dipstick
You add transmission fluid through the same tube where the transmission dipstick is located. You need a funnel used for transmission oil. The funnel is long, narrow and the end can fit into the dipstick tube.
If it is a manual transmission their is not one.
Use a funnel small enough to fit into th dipstick tube and add as needed.
There 's none.
The transmissions from 1991 - 1994 are the same. So the 1991 transmission will not fit a 1996 explorer.
In the dipstick tube.
Do I have to drop the maliford to take out the transmission?
The Ford Explorer was introduced in 1991. There are no 1990 Explorers to take a transmission from.
The automatic transmission fluid dipstick is in the engine compartment , near the firewall , just to the passenger side of the engine . The manual transmission fluid level is checked under the vehicle at the transmission fill plug on a 1991 Ford F-250
There is no "cap' you simply go to the autoparts store and purchase a funnel designed for putting transmission fluid into the Dipstick Hole. It's generally about 16 inchs long.
I dont see why not.
Usually thru the dipstick hole!
Assuming this is an automatic transmission, you can add ATF through the transmission dipstick tube. The dipstick itself will tell you what type of fluid to add.
Transmission fluid is always put in through the Tranny dipstick tube.
Check in the front passenger footwell , under the front edge of the carpet , just to the right of the transmission hump . I believe that is where the fuel pump inertia switch ( shut off switch ) is located in a 1991 Ford Explorer
Located Left side of Engine compartment look down left hand side of cooling fan near Frame Guru Gonsalves
Should be a plug at the side of the transmission - fill to this level
Usually through dipstick tube
It goes in where your dipstick is in the back of motor compartment
thru that tube that holds the dipstick.