This engine has no turbine or turbo. Although the 1996 Ford Ranger does not have a turbine or turbo, it does have a turbine shaft speed (TSS) sensor. It is located inside the automatic transmission.
it is located on the tailshaft of the transmission
The exact mounting location of the turbine speed sensor will differ between brands of vehicles. The sensor will be mounted either on or just below the turbo, and will be a screw in unit with two wires.
There's no such thing as a speed sensor. Do you mean the rev. counter or speedo sensor by any chance?
turbo or non turbo?
It is located in the intake pipe between the MAF sensor and the throttle.
i can't find the iat sensor for my 1987 nissan 300zx non turbo
It does not have a crank case sensor.It does not have a crank case sensor.
where is the turbo super boost sensor located onth 2001 S60 24 T
You can try cleaning the map sensor and checking turbo speed sensor.
On the Non-Turbo it is on the left side of the Throtle body. Turbo model I have no clue.
Where is the crankshaft sensor located on a Chevy 1500 sil. turbo diesel truck?
On the top of the transmission where the axles go in.
The MAF sensor is located on the intake pipe where it exits the air filter box.
1989 supra turbo 5 speed is = to 1985 300zx turbo 5 speed?
if you mean the lambda sensor it could either be located just after the turbo or it will be on the up pipe to the turbo its all according which model you have but just unplug it and unscrew it and replace it and then plug it back in.
Only the Turbo II, III and IV engines had the intake air temp sensor and possibly the 3.0L V6 but I'm not sure on that one. The N/A 2.2L and 2.5L and the Turbo I do not have this sensor. On the engines that do have it, it is located in the intake manifold between the runners for the number 2 and 3 cylinders.
The throttle position sensor is located on the throttle housing on the left-hand end of the inlet manifold.
Update: The optical crankshaft sensor is located inside the distributor, which is on the top front of the engine on the drivers side.
It is the three wire sensor on the driver side end of the cylinder head.
were is the camshaft position sensor on 1999 Volvo s80 turbo
it is located under the back of the turbo in the high presure oil pump cover near the ipr
on the timing cover sensing the damper
under the back-right suppertronic convention metre
camshaft sensor for 2001 f250 is located on front of block above the bottom pulley wheel this is accessed easiest from underneath the vehicle