It's right there mounted to the turbo itself....
it should. the only thing is if one was a diesel. sometimes they have a spacer on the diesel models.
It is located in front of the intake manifold between two runners.
if it is diesel a duramax diesel if its gas it will be a duramax
The 2014 Chevy Silverado 3500HD runs on Diesel fuel and is powered by Duramax Diesel. You can get more information about this vehicle online at the Chevrolet website.
It is the round canister in the rear center of the engine, at the firewall.
NO it don't. The actuator is up on the front axel housing. Now the transfur case does have a switch on it that sends power to the actuator up front.
On my 1997 Silverado the TPS is right in the accelerator pedal. Look close at your pedal for the wire and plug in module.
where is my hood latch located on my 1999 Chevy silverado pickup
22 if its not diesel and 24their if diesel
6.2L idi (indirect injection) not the best diesel trucks..
Chevy Cruz is a diesel engine, some other models that Chevy offers with Deisel engines are the Impala, the Sierra, the Cheyenne, and the Chevy Silverado.
Yes, but it is illegal
Where is the fuel pump on a 2003 duramax diesel
Take old one out put new one in
"Where is the oil plug located for a 2008 Chevy silverado ext cab?"
It is under the dash on top of the HVAC module
On Chevy there is a actuator that sits on the front axel that go,s bad you unplug the wires an unscrew the actuator that run about 114.00 dollars
Need to check the front4x4 actuator on the front housing to see if its working. there is a switch on the top of the transfur case that sends power to the front actuator to ingage 4x4
In your a hole
On the 1999 Chevy Silverado Z71 4WD, the speed sensor is part of a module. It is located next to the transmission housing.
The 1995 Chevy Silverado coolant sensor is located on the front of the engine. The coolant sensor will be a few inches above the thermostat housing.
how to replace a fuel line presure regulator on a 2004 4.8 chevy silverado
Most truck only have one blend door on it. This also goes for a 2005 Chevy.
On my 1993 K1500 Silverado, it is behind the heater/ac blower assy. However, I can not find any info on how to get the assy apart, or where it is connected to the dash switch.
unless you have some serious torque pushing out of that hd you don't want that gearing in that duramax rearend it probably has 4:11 gears which is great for diesel but shity for gas rigs......
no ECM's in a 1981
The heater blower for a 2002 Chevy Silverado is mounted under the dash. It is on the passenger side, in the heater housing.
86 litres on my diesel 6.5 turbo
more then 4 quarts
The intake temperature sensor is located on the side of the air filter case on a 2003 Chevy Silverado 4.3 1500. It is on the top of the engine.
look under the battery tray
under the battery plate
There are many on the engine
It is bolted on the top of the starter.
It is in the tank.
No, it does not have an inertia switch.
There are several and they are all located on the exhaust system.
A 2006 Chevy Silverado came with either a 4.8, 5.3 or the 6.0 and the oil pump on these engines are located at the bottom of the engine inside the oil pan.
the modulater on a 90 shevy silverado is located under the dashboard mounted on the steering colum
If you are refering to the temp blend door actuator, it is located behind the dash on top of the HVAC box. The dash assembly must be removed to gain access.
The 1997 Chevrolet blazer actuator switch is located on the firewall in the engine compartment. The switch is on the passenger side of the engine compartment.
Located under right kick panel
Located behind the starter. Have to take starter off to get to it.
The speed sensor on a Chevy Silverado is located on the tailshaft of the transmission. To remove it, unplug the wire hardness, unscrew the bolt holding it in place, and pull it out.
Pass side firewall.
It is INSIDE the fuel tank
its inside your fuel tank.
Right front of the flywheel
Inside the alternator
It is in the fuel tank, NO JOKE