Pontiac Sunfire
VW Vanagon
Turn Signals and Hazard Lights
Grand Prix GTP

Where is the turn signal flasher located on a 1996 Pontiac Sunfire and how do you replace it?

8910

Top Answer
User Avatar
Wiki User
2006-09-28 07:50:24
2006-09-28 07:50:24

This question has come up several times. The answer seems to be to remove the housing around the steering column and look underneath. There are two flashers. Replace the one on the right. but don't quote me, OK? I stole this answer from one of the other posters

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Remove the panel under steering wheel. There will be 2 flashers. Replace one on right.

User Avatar

Pull off panel under steering wheel. You will see two separate flashers. Replace the one on the right.

User Avatar

when should the vapor canister be replace on a 1996 pontiac sunfire

User Avatar

There is no speedo cable on a Sunfire.

User Avatar

Pull out the old flasher (located under dash pannel above brake pedal, above the horn relay) and put in the new flasher.

User Avatar

how do you repair an inner tie rod for a 96 Pontiac sunfire no repair,replace with new.

User Avatar

I'm guessing that all of the light bulbs have been checked and are good. It's possible that you need to replace the flasher.

User Avatar

You can replace a timing chain on a 2002 Pontiac Sunfire by visiting a local mechanic and having him take care of it for you. This is a tricky part to change yourself.

User Avatar

Flasher should just "plug in" either next to or inside fuse box located by steering column under dash

User Avatar

The labor to replace a clutch on a 1996 Pontiac Sunfire can range from $670 to $850, depending on where you go. This does not include the cost of the clutch itself, which is roughly $800.

User Avatar

OK ... Here's the REAL answer: You cannot change the bearings on a Pontiac Sunfire. You must replace the "Hub-Assembly" they will be the same on both sides .

User Avatar

How is the ignition key switch replaced on the 2000 Pontiac Sunfire? And after replacing the switch would I have to have it Towed to the Pontiac Dealer in order to have the car key programed to the Computer?

User Avatar

Look under the vehicle - follow the fuel line from the tankRemove clamps and support to replace

User Avatar

take the wheel well out first then reach in and turn bulb socket

User Avatar

I've never had to change mine, but it's an in-line filter located near the gas tank.

User Avatar

What it will cost you to replace the distributor cap on a Pontiac Sunfire will vary depending on if you do it yourself or if you take it to a garage. The cost can be over $100 if you take your car to a garage.

User Avatar

No, not just because you ran out of gas but you should replace the fuel filter.

User Avatar

tug the hose Drop the fuel tank, disconnect lines, remove pump and unit, reverse procedure to install.

User Avatar

Pick up a Haynes or Chilton manual for your car. Follow their directions.

User Avatar

Read more: http://wiki.answers.com/How_do_you_replace_the_tail_light_in_a_2000_pontiac_sunfire#ixzz1Nur0XSlq

User Avatar

No, not if it is not defective. If the ignition switch is defective then that is all you need to replace.

User Avatar

See stvndberryhill's answer under 1998 Sunfire horn relays. It is explained in great detail. The guy knows what he's talking about.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.