answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: Where is the turn signal flasher on a 1990 Nissan Maxima?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is the Value of this car?

Nissan maxima 1990


Where is the signal flasher unit located on a 1990 Chevy lumina?

The 1990 Chevy Lumina signal flasher unit can be found beneath the drivers side dashboard. The signal flasher unit will be above the brake pedal.


Is there a fuel kill switch in a 1990 Nissan Maxima?

There is no fuel kill switch on the 1990 Nissan Maxima. There is a fuel pump relay switch that can cause the fuel to be suppressed.


What car engines will swap with a 1990 Nissan maxima engine?

nissan 300xz turbo


Where is the turn signal flasher location on a 1990 Camry?

The 1990 Toyota Camry turn signal flasher relay switch can be found beneath the drivers side dashboard. The turn signal flasher relay switch will be above the gas pedal.


Will a 1990 Nissan automatic transmission fit a 1985 maxima?

no


Where is cranksaft sensor located on 1990 Nissan maxima?

its in the distrubator


How do you remove the factory stereo in a 1990 Nissan Maxima?

the acutually dash removal of the Comfort-Control Toggle Switch in order to remove facing for radio replacment of 1990 nissan maxima?


Location of signal flasher on 1990 Nissan Stanza?

look under the hood passenger side by the washer fluid filler black box with a snap cover. relay flasher should be inside box on theleft


Is a 1989 Nissan Maxima transmission the same as a 1990 Nissan Maxima transmission?

The short answer is yes. Both the 1989 and 1990 models use the RS5F50A manual or RE4F02A automatic transmission.


Where is the turn signal flasher located on a 1990 Chevrolet Celebrity?

The signal flasher on all versions of the Chevy Celebrity is on the fuse block.


What causes a 1995 Nissan Maxima steering to sway while driving?

I had a 1990 nissan maxima that use to do that and the problem was my rack and pinion bushings were bad