0
What else can I help you with?
How many cylinders does the 4 door 92 buick skylark have?
The 92 skylark eather has a 3.1 Liter V6, a 3.8 Liter V6 or a 2.2 Liter 4 Cylinder.
What is the engine oil capacity on a 1998 Buick skylark 3.1 liter engine?
4.5 quarts
Is a 4 door 95 buick skylark 4 or 6 cylinder?
2.3 liter 4 cylinder or 3.1 liter V6
Where are the timing belt marks for a 95 Buick Skylark 25 liter?
iknow were the crank marks are but not the cams
What is the oil capacity for an oil and filter change on a 2.4 liter 1996 Buick Skylark?
Usually 4.5 quarts to 5 quarts
What is the oil capacity for a 1993 buick skylark 33 liter?
According to the Haynes Repair Manual , it says the following: 2.5 liter is 4 quarts All others 4.5 Quarts
Where is the oil drain plug on a 1995 Buick Skylark with 2point3 Liter 4 cylinder DOHC engine?
below the oil filter a little to the right side on the oil pan under the car
Can you replace a 1998 buick regalskylark 3.8 or 3.3 liter engine with a buick 3.1 liter engine?
You can replace your 1998 Buick 3.8 liter engine with a Buick 3.1 liter engine. You will need to change the motor mounts and some of the wiring harness will need to be modified.
Where is the oil pump on a 1997 Buick Skylark 2.4 liter motor?
The oil pump is mounted to engine motor and is located to right front side (in this transverse mounted engine application). The replacement oil pump is Sealed Power #22443573.
What engine liter is in a 1998 Buick Park Avenue Ultra?
3.8 liter
Where is started relay on 97 Buick Skylark with a 2.4 engine?
The starter relay on a 1997 Buick Skylark with a 2.4-liter engine is typically located in the under-hood fuse and relay center. This relay center is usually found near the battery, on the driver's side of the engine compartment. You can identify the starter relay by checking the diagram on the cover of the relay center, which indicates the specific relay locations. Always ensure the vehicle is off and take necessary safety precautions when working with electrical components.
What is the proper torque for head bolts on 1991 buick skylark 2.3 motor?
The proper torque specification for the head bolts on a 1991 Buick Skylark with a 2.3-liter motor is typically around 65-75 ft-lbs (pound-feet) in a specific sequence. It's essential to follow the manufacturer's torque specifications and sequence to ensure even clamping and avoid warping the cylinder head. Always refer to a repair manual for the exact torque specifications and procedures for your specific engine.
