Mercury Sable
Dodge Ram
Geo Metro
Ford Windstar GL

Where is the vehicle speed sensor on 93 metro code 24?

474849

Top Answer
User Avatar
Wiki User
2005-12-30 01:34:47
2005-12-30 01:34:47

there is a small electrical plug on the top of the transaxle; it is directly beside the mount for your clutch cable and near the end of the trans case. it should have 2 wires coming off of it.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Vehicle speed sensor performance.Vehicle speed sensor performance.

User Avatar

Is vehicle speed sensor

User Avatar

This code indicates a problem with the vehicle speed sensor. Check the wiring and if it is good replace the vehicle speed sensor.

User Avatar

Vehicle speed sensor malfunction. Most likely you have a failed output speed sensor on the transmission.Vehicle speed sensor malfunction. Most likely you have a failed output speed sensor on the transmission.

User Avatar

Trouble code P0500 means: Vehicle Speed Sensor 'A' Replace the speed sensor

User Avatar

Trouble code P0500 means: Vehicle Speed Sensor A

User Avatar

Trouble code P0500 means: Vehicle Speed Sensor A

User Avatar

Code 13 is no vehicle speed sensor signal. Check/replace the speed sensor on the tailshaft of the transfer case.

User Avatar

Trouble code P0500 means: Vehicle Speed Sensor A

User Avatar

Vehicle speed sensor range/performance

User Avatar

P0500 is loss of vehicle speed signal. You need to test the speed sensor.

User Avatar

Trouble code P0501 means: Vehicle Speed Sensor A Range/Performance

User Avatar

Code 33 means: Vehicle speed sensor (VSS) or circuit

User Avatar

The speed sensor tells how fast the wheels are turning. The cruise control uses this to maintain the speed. When you get the code for speed sensor it is not working properly.

User Avatar

Trouble code P0501 means: Vehicle speed sensor, range or performance problem

User Avatar

Trouble code P0500 means: Vehicle speed sensor malfunction

User Avatar

P0500 means that the vehicles speed as read by the Vehicle Speed Sensor (VSS) is not being measured properly. Most likely either the Vehicle Speed Sensor (VSS) is not working properly or there is a malfunctioning wire leading to the Vehicle Speed Sensor (VSS). You might notice a loss of anti-lock braking capability, the speedometer might not be working, or your automatic transmission might behave erratically.

User Avatar

According to the wiring diagram that i have - there is no specific fuse for the Vehicle speed sensor.There are 2 wires coming out of the vehicle speed sensor, one is Yellow and one is Purple. They both go to the powertrain control module. (which is located on the left side of the steering column under the dash.) The Yellow wire coming out of the vehicle speed sensor is number 64 on the PCM and is listed as VSS Hi(signal). The Purple wire coming out of the vehicle speed sensor is number 65 on the PCM and is listed as VSS Lo(ground). If the Transmission Speed Sensor is bad you should set a diagnostic trouble code and the speedometer will not work.

User Avatar

The ecu code 17 in the 1988 acura integra is for the VSS (vehicle speed sensor). Hope this helps you.

User Avatar

Distributor speed sensor malfunction.Distributor speed sensor malfunction.

User Avatar

The code 22 in a Toyota vehicle is for the water sensor.

User Avatar

P0720 - Low Output SPD Sensor RPM Above 15 MPHThe relationship between the Output Shaft Speed Sensor and vehicle speed is not within acceptable limits. P0720 - Low Output SPD Sensor RPM Above 15 MPHOutput shaft speed is less than 60 rpm with vehicle speed above 15 mph (4-speed auto. trans. only).


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.