The engine computer, located behind the battery, is the voltage regulator on a 1991 D150 truck.
The voltage regulator is inside the alternator.
the voltage regulator is built into the alternator
It is built into the alternator. It is all 1 unit.
Yes possible. If switch does not open on engine shut down battery will drain If switch does not close on start up battery will not charge
The only engine speed sensor is the pick up plate in the distributor.
A 1991 doesn't have a crank sensor, it only has a distributor pick up plate(cam sensor)
No crank sensor, just the pick up plate in the distributor.
It only has the "pick up plate" inside the distributor.It only has the "pick up plate" inside the distributor.
It only has the "pick up plate" inside the distributorIt only has the "pick up plate" inside the distributor
where is located fuel presure regulator in Nissan pick up 96
That's completely normal, should only happen at start up and for a few minutes after though. Just your grid heater cycling
the Where is the voltage regulator located in a 1992 ford bronco 302?" is located in the alternator. To replace this you first have to disassemble alternator and remove the rectifier bridge and the diodes, once they are removed you can reinstall them by using a tooth pick to hold armature brushes back and reinatll parts. The easiest way is to just plain purchase and alternator for about $92.00 and this will save you alot of time and any possible chance of shorting out regulator and diodes.