It is located on the bottom of the windshield washer reservoir.
Toyota hiace has one common fluid reservoir for both brake and clutch system. it is located left lateral side of dash, it can't be seen when front left door is close.
The reservoir is located on the right hand side of the engine compartment just below and a little to the right of the master cylinder resevior
The brake fluid reservoir on a 1989 Mazda 626 is on the master cylinder. This is located in the engine compartment on the drivers side.
Above the master cylinder, below the brake fluid reservoir lid.
There is no external transmission reservoir. Transmission fluid is stored in the transmission. Fluid is added at the same point at which you check the fluid level.
has to be replaced, its on the bottom up the washer fluid jug.
When owning a car it is important to maintain the fluid levels. A 1989 Toyota Corolla uses 1 quart of Universal ATF transmission fluid.
The reservoir has two line marked, MIN and MAX. They can be viewed from the side. The reservoir is clear and the fluid leve and be checked simple by looking at the reservoir, the level should be between the two lines.
It s under the hood, with an obvious sign on the cap you cant miss it. You can also ask any gaz station with service, they will fill it for you and they can show you it's location under the hood.
Use DEXTRON II. Remove the power steering fluid reservoir cap, and fill the power steering reservoir until the fluid reaches the ''full'' line.
i have a 1989 Toyota Camry le and not sure where to poor the transmission fluid
You add automatic transmission fluid to a 1989 V6 3.0 Toyota pickup truck through the filler tube in the engine compartment. This is also used to check the fluid level.
Fill reservoir 1/2 pint?
Open your hood, Now, on the left side of the engine, locate your coolant reservoir; and, immediately to the right of this should be your power steering fluid reservoir. I hope this helps you.
On the firewall, in front of the booster, on top of the master cylinder.
It is part of the power steering pump assembly.
Near the battery attached to the round brake booster.
The fluid reservoir should be built onto the power steering pump. There will be a cap on top to fill through.
There is a power steering reservoir under the hood of the car. Remove its cap, and the dipstick is attached, this is where a person can check the fluid level.
It goes in the master brake cylinder reservoir. The cap of the reservoir says to use only Dot3 brake fluid. This cylinder is accessible on the driver's side of the car when you open the hood of the car. Do not confuse it with the power steering reservoir which is also on the driver's side. The power steering reservoir is the one closest to the front of the car and the cap on it also tells you to use only Honda power steering fluid.
Yes the transmission will fit. But when converting over you will need a clutch pedal, brake pedal, clutch disc, pressure plate, throw out bearing, clutch fluid reservoir as well as the lines to route the fluid. You will also need the shifter cables as well as the shifter itself. Its not an easy task.
What type of transmission fluid does my 1989 toyota pick up truck take, manual 4 speed.
Ummm...I think it would be safe to say that the washer motor is faulty. Do the wipers work when you push the windshield washer button? Good luck, Mr. Dog
Unfortunately, it is on the valve cover that is closest to the back of the engine compartment...and therefore underneath a portion if the manifold. If you go to the passenger side and lean down near the power steering fluid reservoir and look toward the driver side and slightly down, you can see the pcv valve.