Chevy Astro
Water Pumps
Chevy G20

Where is the water pump located in a 1995 Chevy Astro Van?

91011

Top Answer
User Avatar
Wiki User
Answered
2006-05-03 18:00:42
2006-05-03 18:00:42

Look under the hood for the radiator fan. The fan is mounted to the pulley at the front of the water pump.

012
🙏
0
🤨
0
😮
0
😂
0

Related Questions


engine diagram of 1995 chevy astro vas

`on the right side of engine in the center of engine

Look where the upper radiator hose connects to the engine. There you will find the thermostat.

The 1995 Chevrolet Astro and coolant temperature sensor can be found on the front of the engine. The coolant temperature sensor will be a few inches above the thermostat housing.

Behind the wheels, attached to the axle.

The 1995 Chevrolet Astro fuse box is located in the engine compartment. The fuse box will be on the drivers side of the engine compartment.

Where is the idle speed motor located at on a 1995 chevy blazer?

what size of transmission goes on chevy g20 cargo van 1995

Follow the fuel lines forward from the fuel tank to the engine. Along that route you will find the fuel filter.

Why is the water not circulating in my 1995 C1500 Chevy truck?

fuel pumps whine when they are going bad

The Fuel Tank is 27 gallons. I've had my 95 Astro van since 2000.

The headlight fuse located on a 1995 Chevy Tahoe is under the hood. It is located in the fuse box on the passenger side.

The cost to replace a 1995 Chevrolet Astro van will vary depending on the labor costs and the part cost. The price for the starter starts at $46.00 dollars.

When was the last time the ign. wires were changed?

1995 Chevrolet Astro, 4.3 V6 engine with Single Point Injection System has one O2 sensor located in exhaust pipe (between catalitic converter and the place where exhaust pipes from right and left cylinder heads meets in one pipe).

The 1995 Astro Van center relay switch is located on the outside of the fuse box housing. The fuse box is located on the passenger side of the engine compartment.

Look where the top radiator hose connects to the engine(water pump).

It is located behind the fan and mounted to the engine block with 4 bolts.

it's on the front of the engine block below the water pump

You need an OBDII scanner to retrieve the trouble codes.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.