Loosen and remove the bolts in a crisscross pattern from the center outward. Insert a rag into the block opening and scrape off any remains of the old gasket.
WARNING When working on the coolant system (for example, replacing the water pump or thermostat), a certain amount of coolant will spill on the floor. The antifreeze in the coolant causes it to be very slippery. Always immediately wipe up any coolant that spills to reduce or eliminate the chance of injury.
When replacing a water pump, always follow the procedures recommended by the manufacturer. Most often a coating of good waterproof sealer should be applied to a new gasket before it is placed into position on the water pump. Coat the other side of the gasket with sealer, and position the pump against the engine block until it is properly seated. Install the mounting bolts and tighten them evenly in a staggered sequence to the torque specifications with a torque wrench. Careless tightening could cause the pump housing to crack. Check the pump to make sure it rotates freely. The water pumps on many late-model OHC engines are driven by the engine's timing belt. When replacing the water pump on these engines, always replace the timing belt. Make sure all pulleys and gears are aligned according to specifications when installing the belt.
the starter will be found under the intake if the engine is a northstar.
where is the brake release on Cadillac Seville 1993
1993
195 degrees
195
To find wiring diagram and component location for Cadillac eldorado 1993 and Cadillac Seville 94 access their main web site information or get in touch with local dealers.
yes it can with a flatbed or a wheel lift wrecker
under the car forward of the fuel tank
In the trunk on the left side - Really
under the silver engine cover ...next to fuel regulator
IF IT WASN'T CONVERTED IT SHOULD BE R-12 paul g
nine quarts of oil for the northstar.