hei ignition or edi ignition
It is located on your transmission. You can identify it because it has teeth on the end of it(you can see when it is pulled out of your transmission). Take that out, then disconnect the wire connector and put your new one in place of it
I believe it is behind the engine on the firewall. It is a single wire and connection that breaks out of the main harness.
It is at the top very front of the transmission just to the left of centerline. You can reach up to it from under the truck but may need to disconnect transmission shifter linkage to do so.
The backup light switch is located on the left side of the transmission. Disconnect the switch connectors, then unscrew the switch.
Assuming you mean the vehicle speed sensor, it'll be located atop the transmission near or on the transmission output. Disconnect the wiring (should be a simple weatherpack terminal), then unbolt the VSS.
The transmission filter is located inside the transmission.
Take a lose the four bolts on the yoke located at the rer of the driveshaft size 11mm put in neutral and wiggle it out the tranny
on the back of the engine bolted to the transmission... disconnect battery or else you might get some good shocks going. it can be a knuckle buster but is pretty easy to do.
The transmission fluid is located in the transmission.
What vehicle?
The address of the Advance Community Library is: 19805 State Highway C, Advance, 63730 8286
located inside the transmission pan