0
Where is the wire located to unplug Set ignition timing 87 ford bronco 2?
Wiki User
∙ 14y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What the timing setting for a 1993 Pontiac Grand Am?
UNPLUG THE COMPUTER TIMING CONTROL, and set the ignition to ZERO with engine at idle, hook-up PCM control, YOUR DONE! Good luck, Jamison
How do jump an ignition in a 1986 Honda 250 ATV?
Just unplug it and kickstart it
How do you replace the ignition switch on a mercury grand marquis?
It's located on the steering column 2 screws unplug the harnest
How do you read the timing marks on 1995 Nissan Pathfinder 3.0L if the first from left is -5 or 0 degrees and do you have to plug or unplug anything?
A 95 pathfinder ignition timing is controlled by computer, but 0 is tdc so -5 is the first mark to the left.
Door chime on 88 Ford Bronco II is on all the time how to get to it to unplug it?
now I'm not quite sure about bronco II's but in my 93 bronco the box was located under the driver side of the dash more towards the middle. The box is about 2 x 2 1/2 inches, and has a 7 prong connector I hope this helps
What are the timing specs for a 1989 2door Chrysler Lebaron non-turbo 2.5?
To set the ignition timing, warm up the engine, loosen the distributor clamp bolt, unplug the coolant temperature sensor located on the drivers side of the thermostat housing. Be careful, as this will activate the radiator fan. Once you do all this, you can use your timing light to set the base timing to 12 degrees. Don't forget to plug your coolant temperature sensor back in, and tighten the distributor clamp bolt.
How do you hook up an MSD ignition to a 350 Chevy?
It is simple....as long as you have the right one.....on my 350 the ignition coil was located inside the distributer cap, easy enough, you just take off the 2 bolts and unplug
How to unplug ignition coil module electrical connector?
testing the starter
Why turning my ignition on and wont turn off till I unplug the battery?
The ignition swithch has failed and is making a continued contact
Where is the ignition control module on a 2001 Pontiac Sunfire 2.2L engine?
The ignition control module is located on the left side of the engine, it is what the coil packs are attached to. If you remove both coil packs and unplug the two connections it will come right off.
How can you set the ignition timing on a 1991 Cadillac Brougham?
unplug the wire on the right side of the firewall it should be close to your heater core hoses it is a small wire a male@female connector unplug it . now unloosen your distributor set your timing to 0 Titan up your distributor now plug up the wire.remember the car must be running to do this.now once you have done. unplug the negative side of your battery for 30sec to remove any bad codes.p.s remember to start car before you start this job.
How do you replace a headlight in a ford bronco 2?
There are 4 little screws around headlight, remove then unplug and replace. Vdubwizard
