In the master cylinder, driver side under the hood.
Before you add brake fluid, are you SURE you need to add some? Because as brake pads wear, the brake fluid level goes down, but the brake pads need to be replaced then, BEFORE any brake fluid is added. Otherwise, when the brake pads ARE replaced, there will be too much brake fluid in the reservoir, and it will flow out when the pistons are pushed back into it's bore, to make room for the new pads. -Tom.
Top right corner
its under the side cover
have you tried the dipstick tube.some dodge and Plymouth minivans the dipstick is the "filler hole" this also applies to the transaxle fluid.(transmission)
Good question. At the brake fluid resovoir
The fill plug is in the center rear of the case.
ADD BRAKE FLUID
You open the hood, find the brake fluid reservoir, take the cap off and add DOT 3 brake fluid up to the full level.
You can add brake fluid inside the brake fluid reservoir. The reservoir is located on the driver's side under the micro-filter panel.
Yellow cap, under the hood, driver side, near the base of the windshield.
Fill plug is located on the center rear of the transfer case
Locate the brake fluid reservoir, and pour brake fluid in until it's at the appropriate level.