0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you put fluid in the slave cylinder on a 2000 Toyota Tacoma?
Remember, keep the master cylinder full so you don't suck air into the slave cylinder. Then you put the fluid in the slave cylinder.
What is causing my brake light to come on in my 1998 Toyota Tacoma Non-prerunner I checked the brake fluid and its full What else could it be?
The break light coming on in your 1998 Toyota Tacoma Non-Prerunner might be due to a faulty braking sensor. It could also be the brake cylinder or slave cylinder causing the light to come on. The break fluid being full is a great place to start; check the brake slave cylinder next.
Where is the slave cylinder for the clutch on a 1996 Toyota Tacoma 4x4?
The slave cylinder is located on the driver side of your bell housing going to your motor. Its a cylinder about the size of a roll of quarters.. maybe a little bigger.
Why would clutch fluid leak out on a 88 Toyota corolla?
Bad clutch slave cylinder or failed soft hose from master to slave cylinder.
What if your clutch on your 85 Toyota corolla goes to the floor and is hard to shift?
There are two normal causes. The clutch is worn out or there is a leak in the hydraulic clutch slave or master cylinder. To check the clutch, press the clutch slave cylinder down. If the clutch slave cylinder bellows compresses down to the slave cylinder, the clutch is worn out. Check the clutch master cylinder fluid level. if this is low, then the clutch cylinder need to be checked. To check for a hydraulic leak in the clutch slave cylinder, remove the cylinder's bellows and check for any fluid. If fluid is present, rebuild or replace the cylinder and bleed the system. To check the clutch master cylinder, check the back the of clutch master cylinder for leaks. If fluid is present, replace or rebuild clutch master cylinder and bleed the system. In my experience, hydraulic leaks occur at the clutch slave cylinder.
What type of fluid does the clutch slave cylinder use in a 1998 Mitsubishi mirage?
The clutch slave cylinder in your 1998 Mitsubishi does not use fluid. The clutch slave cylinder is sealed with grease inside of it.
Where do you add fluid for clutch slave cylinder?
In the master cylinder
Where is the clutch slave cylinder fluid located on a Honda Civic?
The brake fluid for the entire system is added in the master cylinder container. The slave cylinder does not have its own reservoir.
What would make the clutch stay to the floor on a 1984 4x4 Toyota truck?
no fluid in reservoir due to leaking reservoir or slave cylinder
What is cost of replacing slave cylinder on 94 4 runner. Toyota?
The part can be purchased for about $12 from autozone. You should bleed the clutch fluid after replacing the slave cylinder. It is common to replace the master cylinder at the same time as the parts have nearly the same life span.
How do you fix a 1990 Toyota Camry clutch wont engage?
check the slave cylinder,if its dry add fluid and then press the clutchin and out about 15 times
Where is the fluid reservoir for the clutch on a 1995 Toyata Van?
The clutch reservoir on a 1995 Toyota will be found on the slave master cylinder. These are located on the firewall of the engine bay.
