0
With regular dry cell batteries, the flat negative (-) side always sits against the spring.
Wiki User
∙ 9y ago
Anonymous
the flat negative end
Add your answer:
Earn +20 pts
Which side of the battery is negative if it's not marked or hooked to a battery?
, If the battery has no markings then you should be able to tell from the sides. The flat end is the negative which pushes down on the spring, and the side with the bit sticking out is the positive which slots in nicely :) hope i helped :) x
How do you make light with a battery?
you have to have 2 wires. then you put a wire to the positive side of the battery(+) and the other wire to the negative side of the battery(-). then both other ends to the light bulb one end to the side and one end to the bottom. you have to have 2 wires. then you put a wire to the positive side of the battery(+) and the other wire to the negative side of the battery(-). then both other ends to the light bulb one end to the side and one end to the bottom.
When putting d cell batteries that alternate negative and positive which one goes with end on spring?
Generally the negative end of the battery goes up against the spring.
What is the difference between a beam balance and spring balance?
A beam balance - has a weight at one end, and it 'balances with the load placed on the other end. A spring balance - has a vertical spring attached to a scale - that shows the weight of an object suspended from it.
Where is fuse box on a 2002 dodge ram?
1500-under the hood, next to the battery.2500,3500-one on the driver side end of the dash, another under the hood next to the battery.1500-under the hood, next to the battery.2500,3500-one on the driver side end of the dash, another under the hood next to the battery.
Where is the computer located on a 1993 Concorde?
The trans and engine computers are under the air box and battery. The body is at the passenger side end of the dash panel.The trans and engine computers are under the air box and battery. The body is at the passenger side end of the dash panel.
When a patient is in bed where is the urinary drainage bag placed?
I've seen the bags placed on either side of the bed. I think it depends on which side faces the doorway - the bag is on the opposite side. Usually about a foot and a half from the end of the bed.
Where do find the fuses for 1999 dodge ram 2500 diesel?
There is one fuse box on the driver's side end of the dash. THe other fuse box is under the hood next to the battery on the driver side.There is one fuse box on the driver's side end of the dash. THe other fuse box is under the hood next to the battery on the driver side.
How to fix if battery incorrect placed on 95 jeep grand Cherokee changed battery distributor coil cap spark plugs and wires and all 60 size fuse smells like fuel now it wont turn over?
There is afuse block in the engine compartment on right side and a smaller fuse block on the veery end of the right side of the dash, open passenger front door and you will see the cover on end of dash, have fun!!!!!!
Where is the fuse box for a 2004 Chevy Impala?
There are three. 1 on the end of the dash on the driver side, 1 on the end of the dash on the passenger side, and 1 under the hood above the battery.
What does plus end of AA battery mean?
If you look closely to a battery there are two symbols. (+) and (-) Batteries have chemical energy both positive and negative. and a battery compartment has a spring and a metal surface. they each conclude different energies ( + and -) so the plus sign of a Battery means positive
How do you make electrical circuits with 2 or more batteries?
There are 2 ways you can go You can hook them up in series or in parallel If you hook them up in series That is you connect the positive side of the battery to the negative side of the next battery and so on you en up with the voltage being increased by the voltage of each battery So if you hook up a 12 volt battery to the end of a 6 volt battery you end up with 18 volts. Or you can hook them up in parallel That is you hook the abaterys together on one side going from positive to positive and on the other side negative to negative When you do this you end up with the same voltage but increase the amperage.
