Hold your clutch disc sideways. The middle hub sticks out farther on one side than on the other. The side it's sticking out farthest on goes toward the transmission. Don't worry...if you put it on upside down the pressure plate won't fit, which is your signal to flip the disc over. The important thing is to be sure you have the hole in the clutch disc exactly aligned with the hole in the gland nut...if you don't, the engine won't go back in.
You replace it. The oil is in the clutch face and if you use it, the face will come off of the disc. There is no way to clean it.
If it is the clutch and not the transmission. The face of the clutch disc may have come off. Dumping the clutch too often can cause this, or can "just happen". It may be packed against the bell housing and hitting the pressure plate. Pressure plate may have lost a spring when the clutch went and it is hitting. You will know when it is taken apart.
For the most part, disc errors are cause by scratches and swirls on the disc face, but they can also be caused by moving the PS3 while the game disc is in it, if the disc is dropped on the ground, or if the disc is flexed beyond a reasonable limit.
Because the animators forgot to draw in his face and animate it.
You can't. The super upgrade is suppose to troll you.
find a/c compressor remove center bolt from electric clutch use a bridge puller span the clutch face plate now put a longer bolt through the center of puller, thread back into the clutch face plate as you tighten the bolt it will pull off face plate.go buy a snap ring remover set then take out the center snap ring the clutch housing and bearing will come off now just bump it with a block of wood.Install new clutch reverse order.remember your air gap is determined by the washers between face plate and clutch on center bolt.if you dont care if a/c works when your done you can force the clutch face plate off with two opposing flat screw drivers after removing center bolt.Now with this info you can make that dreadful bearing screech go away.Dont be fooled by regular auto techs you do not have to replace the compressor to put on a new clutch bearing assembly.Now you have the plan Get to work it will take you 1 to 4 hours on your skill level.God Bless have a great day
Just make the clutch pads line up with the clutch disk. the pressure plate can only go on one way due to the positioning dowels
my face is crazy mad
Standard or automatic? Making any noise of any kind? Standard, the clutch is worn out or the face on the disc blew off. Automatic, low fluid, dirty and plugged the valve body, Shift linkage broke, disconneted.
Super Bowl XLII (42)
The 'big black disc' that move over the face of the Sun is the Moon during a partial or full solar eclipse.
Super mad! If you get in it's face then you will probably get bit or scratch up.