diskcopy
**R1(config-router)# network 172.16.0.0 0.0.31.255 area 0
Command Staff
Duplicate values have no effect on linear search other than to increase search times. When searching for a value that is duplicated, the index of the first element that matches the given value is returned. If you wish to return all indices that match the given value, you must either search the entire array to build a new array of indices, or sort the array so that all duplicates are allocated contiguously and return the range of indices.
a copy command would copy the contents of the selection and when you paste it somewhere else, the original contents would still be there. the contents would be available in both the original location and the new location a cut command would remove the contents of the selection and when you paste it somewhere else, the original contents would be lost. it would be available in the new location only.
The instructions have to remain in memory at all times while the program is running. They get there by loading the entire program into memory. The CPU's instruction registers keep track of the current instruction and the next instruction.
Disk copy DISKCOPY [d:] [d:][/1][/V][/M] where; /1 - Copies only the first side of the diskette, even if the target diskette is double sided. /V - Verifies that the source data was copied correctly onto the destination drive. Selecting this option will slow down the copying process. /M - Forces DISKCOPY to use only conventional memory for interim storage during the copy procedure. Normally, DISKCOPY uses the hard disk for this purpose. After copying, the program will display Disk copy OK Copy another (Y/N) ?__ - reply Y for yes or N for no and the programme will close. This sequance will need to be run under the CMD command when using a windos programme and needing to start the command line editor
You use the 'yank' and 'put' commands. You 'yank' the lines into a buffer (named a - z) and then go to the place where you want to paste or duplicate them, and use the 'put' command to insert them. You can also read entire files or portions of files with the 'r' command to paste contents into other files.
SYSPREP
The best way to remove duplicate iTunes files is to manually delete them on the computer. This entails going through an entire playlist and manually deleting each duplicate entry.
true
hide command
The entire chain of command.
to command = tseevah. But in order to add "you", we would need to see the entire sentence, because it depends on the context.
3
**R1(config-router)# network 172.16.0.0 0.0.31.255 area 0
A small number of producers command nearly the entire market for a certain good of service
data table command