An illegal immigrant.
take out the old one and put in a new one
YES it will bolt right on with no problems. You WILL need the headlight wiring harness from a '70 to accommodate the 4 headlight system though.
On a 1999 C5 corvette manually put the flip up headlight in the up position, remove the plastic headlight trim around the headlight with three screws... put your bare arm under the raised headlight and remove the turn signal bulb with a careful twist.
Because the Show's Creator, Dan Schneider, loves Fresno and frequently mentions it in his other various shows.
Locate the rubber housing of the bulb behind the headlight assembly and pull/disconect it. Unscrew all bolts. Lift and pull out the front part of the headlight assembly and replace the bulb making sure the contacts are aligned. Put back and bolt the headlight assembly and plug.
More than likely you need to repair the headlight bucket section of the nosecone (either side of the grill) and /or replace the headlight assembly. It will take some fiberglass mesh and some resin and hardener .
behind the rad support there are two tabs directly behind the headlight. pull up the tabs and pull headlight out straight. you well be able to get at bulb to replace it.then put headlight back and push down tabs after bulb is replaced.then you are good to go
you take the two bolts on inside of the headlight under the hood, then there is one behind the bumper cover at the btm of the headlight, take those out and when u do pull the headlight out and twist the signal bulb housing out and pull bulb install new one and put it back in
unplug the bulb. remove the metal headlight clips that secure it to the grille. They are located around the perimeter on the front. pull headlight straight out of the front of the car. put on a flat surface. remove lock ring. replace with new bulb being careful to line up the grooves and pins. Firmly push new bulb in until seal at base of bulb is properly seated. replace lock ring. put headlight back through front of grille and replace metal clips. plug bulb in and you are done. Don't try to replace bulb from the back. It is virtually impossible to do it correctly, especially on the passenger side. A poorly installed bulb will cause the holding area to melt from bulb heat resulting in a leak and water filled headlight. I speak from experience. Mine is '91.
Its the transmition bottle behind the front bumper nearside just below the headlight. Stupid place to put it as you have to take the bumper off to get to it..
Actually.. to take the headlight lens apart, put the Oven on 200, put the headlight assembly in oven for a few minutes at a time, as the headlight assy heats up, the adhesive will loosen up making it easy to remove the lens. For a demonstration, go to Youtube and type in "How to remove headlight lens from assembly"
yes but you also have to change headlight assemblies also. not worth doing. just find a 97+ bumper.