0
Why are the locks and the inside dome light going off and on periodically in 2000 dodge neon. The driver's door lock was replaced but the problem still continues.?
Wiki User
∙ 18y ago
Our 2002 Dodge Neon did this today, but we noticed that it also says "door fuse" so we are going to try to replace the fuse. I've have problems with the dome light staying on once in a while. Check also door switches. That is what we plan to do next. Sometimes if we shut a rear door again the light will go off. Later.... we changed the driver side door lock but it didn't solve the problem. Cost less than $10.00. My husband check the switch on right rear passenger but it seemed okay, then he was out of time. We still have 2 doors to go. Hope someone has a better answer.
Wiki User
∙ 18y ago
Add your answer:
Earn +20 pts
What can cause the power locks not to work on a 1990 bronco?
I replaced the drivers door switch on mine and it took care of the problem
If the drivers window switch is working periodically and the power of the motor is weak is there a problem with any relay?
Likely there is a problem with the window switches contacts being dirty or worn. There could be a problem with the supply voltage from other sources being less than adequate.
Fan Doesn't work for your 1988 Mercedes 300E?
change the resistor if the problem continues try the fan with cables directly to battery and you will see for sure that the fan need to be replaced.
Is a drivers license legal in two pieces?
Technically speaking, probably not. The problem is that the license is actually the property of the State which issued it to you. It is NOT yours. It should not be difficult to get it replaced, though.
Why does a 94 mx3 1.6L hesitate when you bring the rpm's up to 35000 to shift diagnostic said 02 sensor replaced it but problem continues?
i had this problem when i first bought my 94 mx3. i was messin around with it alittle bit and my problem was that it wasnt getting enough air. i replaced the air filter and there was some hole in the intake tube. so i taped them up and the problem stopped. so you can give that a try. cheap and easy.
Your car is making a scraping metal sound in the front drivers side wheel the brakes have been replaced and the rotors turned could the rotor be bad?
This may be a wheel bearing problem.
Jeep continues to vibrate after rotors were replaced?
check tires, driveshaft,universal joints Another answer: Do all that. The rotors were not your problem in the first place. They have to do with the brakes. They stop the car. If they were bad, they needed to be replaced. You need to be able to stop your car. You may need a complete front end job.
Drivers seat fuse 1996 Mercedes Benz E320. Why would my Drivers seat function properly until I replaced the battery.Now it will not function.?
I had a problem with mine and it wouldn't go forward. If it moves backwards, it needs to go all the way back before it operates correctly.
Do you put a line on a division problem when it continues?
yes
Suspended drivers license in Michigan but went to California and they issued me a drivers license there. my drivers license is currently expired in Calif now so should I have a problem renewing it?
No, you shouldn't have a problem
The drivers window is stuck half way. The rest of the windows work fine. Is it a fuse problem?
More likely it is a window regulator, or maybe a guide bearing. Both are cheap parts that are expensive to have replaced.
1995 Chevy Tahoe 4 wheel drive wont work?
had this problem with my 95 tahoe.. replaced the accuator no help check the 4wd fuse in the fuse box near the drivers door 20 amp...........
