answersLogoWhite

0


Best Answer

because it is old and you might need to buy a new one

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why do riding lawn mower blades start and stop turning?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why won't engine start after engine stopped with blades engaged this is a john deere riding mower.?

Turn your blades off.


Why does your yardman riding lawn mowers belts squeal and engine shuts off when blades are engaged?

More than likely you either have a bearing seized up in one of the deck spindles, a bent blade that is in a bind or debris on the underside of the deck keeping the blades from turning. If this is the first time it has been used in a long time, with the mower off, work the blades back and forth by hand until they move freely then start the mower and try to engage them. If they do not start to move freely then you will have to figure out which one is not turning and take it apart.


How do you jump start a riding lawn mower?

Same as a car. Jumper cables, neg to neg, pos to pos, out of gear, turn blades etc off, start as usual


How do you know when riding mower deck spindles are bad?

Normally you will start to hear a loud grumbling sound from underneath the mower when the blades are engaged. With the mower shut off, release the tension from the belt for the blades. Raise the deck so you can grab the blades from the bottom. You should not be able to rock the blades from side to side or up and down. If you can then you probably have a bad spindle. You can do this for wach of the spindles to check them all.


Your riding lawn mower battery is dead and have no power Can you jump start your riding mower with your car?

yes.


How do you start a LT 150 riding mower?

Disengage blades, push down and/or lock it and turn the key. If nothing happens, the most common parts for failure are the key switch and the solenoid.


Where is the safety switch located to start the mower because you have to press the clutch a lot of times to get it to engage to start This is on a Ranchking riding mower.?

The safety switch to start the motor on a Ranchking riding mower is located in the ignition. If the clutch needs to be depressed several times before the mower will start, there might be a problem with the adjustment of the clutch.


Is there an ignition on lawnmower that you have to turn on?

Not on a push mower that has no electric start. On a riding mower, yes there is an ignition key.


Is a zero turn lawn mower a riding mower or a push mower?

Zero turn lawn mowers can be either a riding lawn mower or a push lawn mower, depending on you're preference. Push lawn mowers start around three hundred dollars.


Do you start John Deere riding mower rx 63 by key or pull start?

Pull start only


Is there such a Snapper riding mower model 195707?

yes there is. It is an 8 hp mower with pull and electric start


Mower turns over but wont start and yes it has gas?

clean the air filter (after each use!), check spark plugs, look for anything wound around the blades like a string or wire stoping it from turning.