answersLogoWhite

0


Best Answer

When you release the clutch, you apply load to the engine. Running rich and black smoke when a load is applied are indicative of a need for a full tune-up (new spark plugs, air filter, etc).

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why does 1985 ranger run fine with clutch pushed in but when clutch is released motor runs very rich and has black smoke out exhaust and runs rough?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why does your clutch go to the floor in your 83 ford ranger?

because i pushed it there with my foot


How do you change a 1993 Ford Ranger clutch?

how to i change a clutch in a 1993 ford ranger


What would cause a 2000 Ranger 4-cylinder engine to race for several seconds pushed when the clutch is in It happens when the engine is cold or warmed up.?

First check for mechanical interference from the clutch mechanism to throttle linkage.


How do you bleed the clutch line on a 2004 ford ranger edge?

how do I bleed the clutch system in a 2004 ford ranger


How do you Remove clutch interlock switch on ford ranger?

How to replace a clutch interlock switch on a 1997 Ford Ranger XLT


How do you disconnect the hydraulic clutch on a 1987 Ford Ranger?

on the side of the transmission where the hydraulic clutch line goes in the trans there will be a white clip on the line push in toward trans with flat screw driver and it should just pop out that's after its pushed in all the way


How do you remove the fan clutch on a 2001 Ford Ranger?

you have to have fan clutch wrenches


Is there a clutch adjustment on a 1993 ranger?

On the 1996 Ranger the manual shows to lift the clutch pedal every 5,000 miles to adjust the hydraulic clutch , I don't know if yours is the same


How do you adjust the hydraulic clutch on an 85 Ford Ranger?

On a 1996 Ranger the manual shows to lift the clutch pedal every 5000 miles to adjust the hydraulic clutch - I have no idea if your's is the same


What kind of hydraulic fluid do you put in your Ford Ranger 2.3 for the clutch?

DOT ( 3 ) brake fluid is used for the hydraulic clutch in a Ford Ranger


My 1990 ford ranger will not shift into gear?

A 1990 Ford Ranger may not shift into gear if the clutch is out. A clutch can be purchased at any auto parts store.


What would cause 1988 ford ranger exhaust manifold to get red hot?

exhaust?