Because someone switched the lines or labeling. <
1- Someone installed the piping not bothering to read modern codes requiring water hot and cold to be 6" apart
2- C/W supply to a tank or other heat source does not have the 27" heat trap (loop) to prevent stratification of hot water molecules entering the potable water supply
3- Failure on the part of an installer of appliances that use both hot and cold water supply to have an air gap or vacuum breaker or the very least a check valve
4- Cold water lines picking up ambient heat from the surrounding air or close contact to heating lines
5- Cross connections see #3
cold water tub facuet is corroded bye hard water builtup and needs to be replaced. Hot water is okay. Its the right one with the cold water coming out
Obviously hooked up wrong, or the faucets are mismarked . Usually cold on the right, hot on the left.
if it is a single lever faucet the cartridge needs to be replaced. check the supply valve under the sink first,
If you have an instantaneous hot water heater, and your faucet doesn't flow enough water it won't turn on the water heater. Thus requiring another faucet to be turned on.
Because you are using the Hot water faster than the boiler can produce it. Turn the tap/faucet off a bit. Get the proper sized boiler
Unless there is a recirculating pump the hot water has to come from the hot water heater. Depending on how far away it is from the faucet, it can take 15 to 30 seconds for the hot water to get there. Since there is nothing in the pipe to keep the water hot, it cools down between uses.
Yes
I'm no plumber, but I would imagine that (if the hot faucet is giving you cold water) that the hot and cold pipes leading into the bathroom have been somehow switched.
If water is only drawn from the cold faucet, then no, the water heater is not involved. However, if water is drawn from the hot faucet- even for a few seconds- hot water IS withdrawn from the heater, and fresh cold water drawn in to be heated- even if the hot water did not make it all the way through the pipe to the faucet- and the water heater will work to heat that fresh cold water.
The seals in the faucet most likely need replacing.
true, the water is going to get hot either if you use cold or hot water You did not answer my question of if it was "true" or a "myth" that the water had to be from the cold water faucet. From what you did respond to it sounds as if the question I generated means it is a myth that the water "has" to be from the cold water facuet.
Kitchen faucet? If so, the sprayer attaches to the underside of the faucet in the middle.
Burn your tongue and throat is about the only issue. Hot faucet water is no different than cold water you heat on the stove or drink in your coffee.
It's probably not the faucet. It could be that there's an obstruction in the hot water side of the fixture, but it's more likely that the hot water isn't getting to the fixture in the first place. The easiest thing to check is that the hot water valve at the wall under the sink is on.
If it had been working fine -- then if it is a cartriage type -- replace it --
You probably have a blocked or frozen pipe into the H/W tank.
You have a cross connection on a faucet somewhere in the house. That means the hot is overriding the cold because of a malfunctioning faucet. Usually happens at the tub/shower diverter if it is a single handle.