0
because they dont big enough anti-freeze tanks
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Why does a 1998 Bonneville sse stall after engine heats up?
Fuel Pressure Regulator - would do that -
Why does 350 Chevy engine stall out after putting it into gear and will flood out?
Need to know the year and what it is in.
Egr valve 1994 Chevy 1500?
The EGR valve on a 1994 Chevy 1500 is located on the top of the engine. If the valve becomes stopped, the engine could idle rough or stall.
What causes a Chevy 5.0 engine to stall at normal speeds?
Need to know the year and make, It would help answer.
How do you in stall a Quarter Window in a 98 Chevy blazer?
how to in stall a Quarter Window in a 98 Chevy blazer
What will cause a car to stall in a 1998 Chevy Malibu?
Stalling at idle? Immediately after starting? While driving? While stopping? Cold or hot engine? What engine do you have?
Why would the engine stall when it heats up in a 4WD 1991 Ford Explorer?
The O2 sensor is BAD and needs to be replaced. Whats happening is when the engine is cold the sensor sends an air to fuel mixture signal to the computer that satisfys the engine's requirements at start, but when the engine heats up the sensor then send a leanner mixture (To much Fuel) that the engine can't burn off so the Sparkplugs get wet and misfire stalling the engine.
What could be the problem if your 92 Chevy Corsica is driving fine and then it starts to sputter and stall it cranks back up and stalls when put in gear?
TCC Solenoid.
Why does my 1989 Chevy Celebrity stall after high speed?
It sounds like your engine is not getting enough fuel, try checking the fuel filter.
Why does my chevy s-10 truck stall while driving?
If the check engine light has come on, have the codes read. That would be a good place to start.
Why does your 2001 Chevy Impala engine shut down on occasion just like it is out of gas even though it is almost full and then after you wait for a short time it starts right up and may be fine for an?
I had a similar problem, and it turned out to be the Crankshaft Position Sensor (located behind the harmonic balancer). It would short out and cause the engine to stall.
Why does the engine die and then run fine after 5 minutes?
One common problems is a plugged catalytic converter, if the engine starts fine and then starts to stall or feel like it does not have any power after running for a while it could be the catalytic converter.. the engine starts loosing power because the exhaust has nowhere to go (the catalytic converter is partially or totally plugged) Compression starts to go down causing the engine to stall or die. If you leave the car alone for a while the pressure in the engine goes out slowly thru the catalytic converter leaving the car ready to start again for a few minutes but it will shut down again.
