The reset is a high limit safety device that cuts the voltage off when the temperature of the water tank becomes too high. If you feel that the water temperature is hotter that usual this is a good sign that the thermostat is not working. Check and make sure that the setting of the thermostat has not been altered. It should be set for around 140F. If the setting has not been adjusted then there is a good chance that the thermostat needs replacing
It pops because the grease's temperature is hotter then the water or food supply that your are examining by the grease being really hot the cooler temperature of the substance causes the grease to pop and crackle
Hot water will dissolve soap faster because it is more hot so that means it will melt is and also evaporate with the water.
Yes, it does last longer in hot water because of the humidity.
because they are dumb
Of course. Pop is carbonated; it has carbon dioxide dissolved in the water. Once all the dissolved gas escapes you end up with plain water with pop flavoring = “flat” pop. I’ve heard of people who’ve drunk pop cans that are twelve years old!
Hot water, nothing aside from getting wet. Boiling water might pop it but it's doubtful. Plus you'd have to subject your hand to boiling water which isn't safe.A heater, also nothing unless it touches the heating element & if it's hot enough it'll pop.
hot balloon will pop first
because the glass will pop if you put the very hot water into the glass
Open the pop off valve on the top and see if air releases. If this does not work may need to replace water heater. This is very dangerous and can explode if the pressure builds to high!!! How do you know it's vapor locked?
It pops because the grease's temperature is hotter then the water or food supply that your are examining by the grease being really hot the cooler temperature of the substance causes the grease to pop and crackle
Dip it briefly in hot water and out they'll come.
Hot water will dissolve soap faster because it is more hot so that means it will melt is and also evaporate with the water.
The hot water heats the air inside the ball, which expands and forces the dent to pop out.
Most are located at the top of the storage tank. That will be the location of the highest heat.
Heater core should be behind glove box. Remove glove box and screws( approx. 8) that holds cover in place. Pop hood and look for two hot water lines running into firewall at that location(passenger side) Remove lines by loosening hose clamps(advisable to replace) Remove heater core from inside and replace.
IF YOUR ON A CITY WATER SYSTEM AT NIGHT THE PRESSURE GETS REALLY HIGH. PRV'S SOMETIMES GO BAD AN LET WATER BY. MOST OF THE TIME A WATER HEATER POP OFF GOES OFF. IT SOUNDS LIKE YOU HAVE A CHEAP FACUET AND NEEDS REPLACING OR A PACKING NUT TIGHTEND.
It will pop just like water just not a bad