THATS BECAUSE POWER IS ROUTED AROUND THE RESISTOR BLOCK WHEN YOU SELECT HI-YOU NEED A NEW(BLOWER MOTOR) RESISTOR BLOCK-SHOULDNT COST MORE THAN 20 -30 DOLLARS AT NAPA
Where do you find the blower motor relay on a 1996 Plymouth Voyager?
the resistor is gonna be right off the blower motor attached to the blower motor by a wire harness should be by the heater core
If you are referring to the blower motor squealing, then I would suspect the blower motor bearings have failed.
Go to Rockauto. com and look up the part # on them. You do have the same size motor in both vehicles?
5w30 or 10w30
behind the motor, on top of the exhaust.
Under the hood, over the top of the passenger side strut tower.
The blend door actuator is under the glove compartment near the blower motor. You will see a wire attached to it and will need a small nut driver to remove it.
No the number and the style of electrical plugs are different. Plus the 1997 has an extra motor mount.No the number and the style of electrical plugs are different. Plus the 1997 has an extra motor mount.
The blower motor is under the dash, far passenger side.
How to change blower motor on 2000 grand am gt
The blower is located behind the GLOVE BOX. Remove the GLOVE BOX and there will be 2 wires going into a plastic housing. In that plastic housing is where the BLOWER will be located. Let me know how it went.
o4 grand prix gt blower motor were is it located
inside the motor
Blown fuse, bad blower motor switch, blower motor itself, or a defective blower motor resistor pack.
The blower motor speed resistor is burned out. Keep in mind that in many cases the speed resistor burns out because the blower motor is failing and drawing to many amps. So if the new resistor burns out soon, next time replace the blower motor also.
Remove the glove box then the four (4) hex screws on the blower motor cover. Then remove the mounting screws for the blower motor and set it down on the floor - it should have enough length in the wiring. Disconnect the the wiring connector them remove the rubber grommet and wiring harness through the blower housing. Installation is the reverse of removal. Good luck!
Where is the radiator fan relay at on a 2000 Plymouth voyager
can be the heater blower motor resistor located in either the ductwork or under hood near blower motor on firewall
Likely that your starting motor needs to be reconditioned/re-built
Remove the door panel and check for power and ground at the motor connector. If you have both power and ground the motor has failed.
5w30 or 10w30
Begin by removing the wiring harness from the back of your blower motor. Remove the blower motor retaining bolts. Remove the fan from the front of the blower motor. Reverse the process to install your new blower motor.