Blower resistor needs replacement
Relay for low speeds needs replacement
Blow motor needs replacement (one of the 2 windings burned out)
more than likely will be the blower motor resistor has went out.
it is the blower motor resistor. it works on high because on high it bypasses the switch
Check the blower motor resistor
Green with black stripe
If you mean the blower only goes in the high mode check the blower resistor located in the plenum under the wiper module.
Blower Motor Resistor is bad. 20.00 part at AZ.
bad blower,buy a good one and replace
That is usually a failed blower resistor.
sounds like the blower motor resistor is out on the lower speeds.
Resistor on the heater blower motor has failed
Try the floor to the front left. There should be a switch you can press with your foot.
No, the blower motor speed resistor is burned out.