Want this question answered?
Where the fuse for the side rail on my truck
truck start shift is hard to move in gear
at the start of your shift
The computer module in a 2003 Mercury Mountaineer is located behind the rear right panel in the truck space. The rear right seat belt panel must be removed and then the lower panel. The module is located beneath a green plug.
My front wheel bearings just went in my 04 mountaineer, and we tried to replace them ourselves, but in order to get to the bearings you have to have the truck up on a lift, so unfortunately we had to send it to a mechanic.
First of all, if its a standrd truck, you push the cluth start and make sure the stick shift is at neutral then start the engine and if its automatic, just put the key in!
Look under truck at drivers side front between door and tire. If ya see the the front axle driveshaft andya have NO auto/4x4 hi/4x4 lo select switch above cigarette lighter then its AWD. i have a 2000 mercury mountaineer awd. Also the 5 liter v8 was awd.
On my 97 mountaineer you cannot open the hood with the release inside the truck. Standing in front of the truck on the drivers side behind the grill the cable is located to pop the latch. Carefully pull out the bottom right side of the grill and you have to have a skinny arm reach in and pull downward on the cable itself this will pop the hood...
alternator and od solonoid
Those are pressure fitted with a special tool. Your better off bringing your truck to a automotive repair shop to have them done. I couldn't find the right tool to do the job anywhere.
97 Chevy Z71 truck will not shift into third gear.
Your truck may not shift gears because the transmission sensor is damaged or broken. It also may not shift gears because the transmission or linkage is damaged.