0
Either the keyswitch has failed or the contacts inside the starter have fused.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
99 Jeep Cherokee Laredo stay running after turn off the ignition switch?
99 jeep Cherokee Laredo stay running after turn off the ignition switch?
Your car starts at starter but not at the inigition and dont stay running once you let off the starter?
Make Model and Year please.
Fuel shut off switch 1996 ford e 350?
1987 Ford F350 want stay running
Would a faulty dimmer combo switch cause the headlights to stay on without the vehicle running and the switch turned in the off position on a 1998 Olds Intrigue?
yes it will also cause them to blink off & on and
If the starter of an 1988 Aerostar will not shut off but does stop running when the key is off is this the relay or what?
bad soilinoid on starter
What does a starter relay cut off switch look like on a 94 dodge spirit 3.0?
where is the starter relay cut off switch located on a 94 dodge spirit
Switch off lights when engine is running on a Volvo V70?
your headlamp switch on the dashboard has a small screw on it. its a 3 position switch. turn it to switch daytime running lights off.
Why does my Car engine continue running when the ignition is switch off?
It sounds like your dizzy cap isn't lined right which causes the engine to stay running after the ignition has been switched off. i had the same problem with my fiesta
Does the fuel pump switch need to be on or off?
On when you are running and off when you are not.
On a 91 ford explorer the question is why would the starter not only stay engaged to the flywheel after the engine has started but keeps running even after the key and engine have been turned off?
The 1991 Ford Explorer should have a separate starter relay that sends power to the starter. It sounds like the relay has stuck and is sending power to the starter even after the vehicle is running.
If the headlamp switch is in the auto mode and the vehicle is running in a 2005 Chevrolet Silverado Crew LS can the headlamps be off?
You hit it down to the off position and it will spring back to auto, but they will stay off until the next key cycle. I am trying to see if I can modify mine to stay off until I hit the switch....we'll see what happens.
How do you wire in a toggle switch to start the car?
By passkey. If you are talking about a starter by-pass. It is not keyed, but a push button on & off switch. You must break the small wire at the starter relay, or solenoid, and wire the switch in series. After the car starts, you must release the push on/off switch, or you will keep turning the starter motor.
