Most likely a bad ABS sensor or broken wiring. Most suspect is the connector atop the rear differential. With bumps and the up/down motion of the rear end, that particular wire gets pulled repeatedly - often resulting in a break in the wiring. That's where I'd check first!
there is a major problem in the brake system if both lights stay on. have it checked before you have no brakes at all
there is asensor on the rear diff...replace that and you should be ok
How do u remove break light sensor
security light on 1998 s10 start but cut off
There are several reasons the airbag light will stay on, in your 1998 Dodge avenger. The most common reason is the airbag sensor is not functioning properly.
Low coolant?Bad sensor?
Have vehicle scanned to determine the problem
You could, but the ABS light will stay on.
Bad sensor? == ==
A defective or out of adjustment brake light switch.
You can reset the check engine light, on your 1998 Land Rover, by repairing what ever is causing the light to stay on. You can determine the cause by using a diagnostic tester.
Is the brake fluid level LOW in the brake master cylinder in the engine compartment ?