Why does your 94 Mazda Protege not start It was starting with no problem a couple of days ago Now for some reason it does not you found that it ran out of gas due to a broken gas gauge and you put gas?
There are two main types of no-starting conditions. Cranks but won't start, and no cranks no start. For a no crank no start condition it is best to suspect a problem with the starter circuit. For a cranks but won't start you have to remember that an engine requires the things to run gas, air, and spark. So what type of condition do you have?
Its a bit challenging.. But you need to remove a couple of plugs mainly the harness that runs along the top of the engine its black. Once you do that remove the coils and wires, and begin to unscrew the bolts When you install, just do it hand tight and tighten in an X pattern starting from the middle working left to right and then the edges
How do you fix a 1995 camaro z28 that stalls out at random times and has to set for a couple of hrs before it starts.?
Next time it stalls, have a can of starting fluid with you. Use the starting fluid and a helper to see if the engine will pop a couple times when it won't run otherwise. If the engine will run as long as you keep shooting brief bursts of starting fluid, then your camero has a fuel delivery problem... probably a clogged fuel filter, but not necessarily. It could be your distributor shorting out, or your…
Oil pressure gauge reads zero after starting the engine then in a couple of minutes goes up a little then jumps to normal and stays there?
I am working on the same problem in a 1999 Elantra Wagon, and have read that it could be the crank sensor. Hope this helps. here are a couple of possiblities: bad crank sensor, broken or jumped timing belt, bad fuel pump, bad cam sensor. Answer was this the only problem or was the transmission not shifting before too?
1994 ram w 5.2 Will run for a couple minutes then pop stumble If you shut the key off then back on it is perfect for a couple minutes then the same thing?
If the cooling fan doesn't work try to power it up with a couple of jumper wires to a battery to see if the motor is the problem. If the fan works then start by checking the relay & temperature sending unit that controls it. Possibly also a wiring problem, check the harness and plugs for corrosion as well as for broken ground wires.
Broken down condenser /s The motor has a couple of condensers usually attached in a little box on the side of the motor. these store a surge of power that helps the motor when it is starting. If they break down the motor will hum but not go. with a bit of luck that will be the only problem. It is called a motor capacitor. This can be checked and if bad this will keep…