Chevy Trucks and SUVs
Chevy Beretta
Chevy Blazer S-10
Late Model 1979-New Ford Mustangs

Why does your ABS light stay on after having new brakes put in a 92 beretta?

646566

Top Answer
User Avatar
Wiki User
2005-12-17 23:35:01
2005-12-17 23:35:01

unpluged abs bad brake job

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Depends on where you are riding it. If you stay in bikeparks and backyards it's OK, but if you ride it in traffic you have to have brakes.

User Avatar

some how the tail light wire is touching the ajar wire

User Avatar

There is a sensor in the side of the radiator that is most likely defective.

User Avatar

New brakes have nothing to do with it. The prolem is with the Anti-lock Brake System, and not the brakes themselves. Take it to a professional.

User Avatar

there is a major problem in the brake system if both lights stay on. have it checked before you have no brakes at all

User Avatar

It should be on a delay and shut off after 10-20 minutes.

User Avatar

The Antilock Brake System or ABS light stays on in a 1997 Nissan Pathfinder because there is a problem with the brakes. The brakes are either low on fluid or they need to be changed or adjusted.

User Avatar

The abs light is a separate system from the brakes.. I know that sounds funny but the abs system is after the break system. Your brakes will still work if the abs is inop. The brake light is usually a fluid level indicator in the master cylinder, not a light to tell you to replace the pads or shoes. I would look for a fluid leak or a problem with the parking brake.

User Avatar

you need to replace the brake light button under the brakes inside the car

User Avatar

The "Emergency Brake Light" IS A FAULT WARNING LIGHT not park brake light onlyThis means if the LIght stays on THERE IS A SERIOUS SAFETY PROBLEM with your brakes.You brakes need to be checked before you have a COMPLETE BRAKE FAILURE and crashTake you Van to a qualified person BEFORE YOU DIE

User Avatar

A problem with your anti-lock braking system. Your brakes and your ABS are two different issues. Your ABS system keeps your brakes from locking when coming to a hard stop. If it is not working correctly your light will come on. Best to have a shop look at it.

User Avatar

Your brake system needs repair immediately. The brakes are squealing because the pads are worn out, and you are hearing the warning device or the metal to metal contact of the pad and rotor. Stop driving the car and have the brakes repaired. The ABS light may or may not go out. If it does not, there is problem with the ABS. Your standard brakes will still work.

User Avatar

Could be low on brake fluid. This is a sign that the brakes need attention.

User Avatar

Get your brakes checked. It can be something simple, or it can mean impending doom.

User Avatar

You have a problem with the ABS system. Your brakes will still work properly but you will not have the extra safety of ABS. Have this checked out.

User Avatar

Any light that stays on is not a "brake light", it's a "tail light". It's possible that they may be on at a lower level normally, and brighten when the brakes are applied, though.

User Avatar

If the light stays on when the emergency brake is not engaged, this indicates the brakes are getting low and need to be replaced.

User Avatar

A malfunctioning brake light relay switch will cause your 1993 Toyota Corolla brake lights to stay on all the time. The brake light relay switch is located beneath the drivers side dashboard.

User Avatar

There could be an issue with the anti lock brakes if it equipped with them. It could also be that the brake fluid is low or the switch for the emergency brake is broken.

User Avatar

The brakes make the car wheels stay still


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.