More than likely you have a vacuum leak. Check all the hoses, make sure none are torn, britle, and disconnected.
YOU WILL HAVE TO INCREASE THE IDLE RPM.
changed battery in 2000 chrystler sebring and now will not idle
when a dozer is idling its rpm are at 90,000 to 95,000 Could be dirt in the carb's idle circuit. Maybe a vacuum leak.
when the engine starts and is warming up the idle is supposed to be at around 1500 rpm but when the engine warms up the idle should drop to between 700 and 1000 rpm. if it doesnt drop then see a mechanic because it is a very complicated fix
It is normal for the RPM to increase a little when put in park or neutral. If the RPM increases by a lot, then you need to adjust your idle speed.
If you need to increase the idle you either have a vacume leak or the iac (idle air control) valve needs replace. Because this motor are control eletronicly.
mass air flow sensor
As you increase rpm, the oil pump runs faster, thus creating more pressure.
It will idle as low as 600 rpm.It will idle as low as 600 rpm.
when u first start the car it will idle high, around 1.5 rpm to 2 rpm. when its warm up it should idle between 700-1000 rpm
the idle should be about 900 RPM in park or neutral.
the RPM should idle 700 - 900