Sounds like the key and/or lock is worn. Try appling a graphite lock lubricant to key and lock assembly. Could also try using the spare key, it may not be worn as much.
check emc fuse and the fuse next to it
It's broke you idiot!
well did this happen to happen to you too!!
First, replace the battery. Then, cycle the ignition between on and off three times. Turn the ignition key into the on position, then the off position, three times. The computer will recognize the key, reboot the computer, and release your key.
how to remove key stuck in ignition switch in Chevy colbalt
Well, it sounds like the chip that is in your key may have broke or got stuck on a part of the ignition. I had that problem. This happened not long after I had had to have the ignition replaced?!?
I have a 93 S10 Blazer and sounds like the ignition lock cylinder is stuck/broken. Try shaking the steering wheel left and right briskly while trying to turn back out the key, making sure to push in on the key and lock shaft.
There should be a lock on the ignition a push button that you push and turn to remove the key
bad ignition switch - inside steering column
A guy has stuck his key in your ignition
Ignition switch! Try turning the key to "on" position without starting vehicle. Leave key on for about 10 seconds. Try this twice. I had a 1997 Chevy blazer that was getting no gas or spark. Drove me crazy for three months. pulled fuel pump ,(was working fine). Truck would turn over ,but would not start. It ended up being the ignition switch. My key & tumbler was ok, but the switch in there wasn't. Cost for ignition switch is about 130.00.
To remove a key that is stuck in the ignition on a Peugeot 406 HDI, make sure that the car is in park. Then try to remove the key. If this does not work, spray the ignition mechanism with WD-40 after pulling out the key as far as possible. Then work the key in and out until it comes out.