0
Why doesn't replacement Napa Power Supreme re-manufactured power window motor work for your 92 Ford Aerostar after you install it?
Wiki User
∙ 16y ago
Did you check for power to the motor? If the switch doesn't work then the motor won't work. If there is power to the connector that hooks onto the motor then the part may be defective, if not then trace it back.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How to install a heater core on a 1992 Ford Aerostar van?
See previous question of same nature.
How do you install starter in 1993 cutlass supreme?
Stick the starter in the cutlass supreme.
How do you install electric cooling fan on ford aerostar?
you go under the house then take out all of the ducting and then you put the new ducting in.
How do you install replacement headlight bulbs on the infinity g35?
take it to the dealer
How to install freeze-12 in 1989 celebrity?
If you add anything other than what the manufacture has no liability for defective. Meaning that if you bought a new or remanufactured compressor and it went bad it would not have a warranty.
How do you replace torn boot on 1996 villager powersteering unit?
You'll probably have to install a remanufactured steering rack unit. I'm not aware the boots are available as a separate part any more.
Where you can find a F29F radio diagram installed in a 1992 Ford Aerostar Van?
You can try the Install Doctors at www.installdr.com. This a good source of info for stereo installs. .
What would be a good estimate for parts and labor to install a remanufactured tranny for a Chevy 4.8 Ltr 1500 4x4?
$3300. $2100 for the trans. $900 to put it in, plus tax exhaust gaskets etc.
Is there any other way to install a power steering pulley on a Ford 92 Aerostar without the special tool?
the pulley has to be pressed on and off. so, i would say no.
How do you install a crankshaft sensor on a 1993 Oldsmobile Cutlass Supreme?
It takes a special gauge to install the crank sensor. It can be rented from some parts stores.
Can a homeowner install replacement windows, or should a homeowner hire a contractor to do the work?
A homeowner may be able to install replacement windows if they have some experience, and good directions. However a contractor may be the safer bet, as they have lots of knowledge and experience in the area.
How much does a clutch cost for a 95 neon and how long does it take to install?
clutches can cost aneware from $300 to aprox $3500 dependinging on wether you want new oem or remanufactured oem or aftermarket so go to your locar parts store and price it out and install time depends on if you now what u doin or not
