Depending On What Vehicle You Have You Probable Have A Blown Heater Motor Resistor. It Will Be Located In The Engine Compartment, Near & In The Housing That The Fan Motor Is In. It Should Have A 3 or 4 Wire Plug In It. Also 3-4 Small Screws Holding It In. Also It Is Kinda Wierd Looking. This May Help.
Doesnt have GPS
It doesnt
Electrical heating element, electrical blower - blows hot air.
very weird and he doesnt work in spanish
It doesnt work under makup because your too ugly
if it doesnt work on 1 and 2 it could be a blower motor resistor but if it doesnt work at all check the fuses, relay and check voltage if it reads 12 v replace the motor
It should do.
Your blower switch sensor is out. Replace it!Then all the speeds will work
either the blower control switch or the blower motoer needs replacing
truck blower only work on high
try wiggling the wires at the blower resistor if don't work then tap on blower motor
When you find out let me know I have same problem replaced blower fan and resisitor did not work. I have a blazer zr2 2002
the blower resistor controls the fan speeds
from what i have read it is the blower motor resistor it goes bad and only lets the fan run on high google blower motor resistor and read on
A blower motor that only works on high is normally caused by a defective Blower Motor Resistor Pack. DRL, do not have a clue.
switch contact"s
Blown fuse, bad motor, bad blower motor switch, or a defective Blower Motor Resistor Pack.