"Noisy" because the engine is vibrating more than normal? Low idle will cause the engine to shake. Low idle can be caused by - Dirty/clogged/sticking EGR valve - Vacuum leak or air intake leak - Dirty MAF sensor
Yes the 1994 Mazda Protege is a OBD 1 port
where is the modulator vavle on my 1994 Mazda protege dx?
The starter, on a 1994 Mazda Protege, is located on the driver's side of the engine. It is just behind and to the right of the oil fill cap.
No, it has motorized seat belts. The 1994 Protege is essentially the same car as the 1990 Protege, which is an economy car that cost about $10,000 new.
The first Mazda Protege, also called the Mazda 323 and the Sixth Generation, was manufactured in 1989, and the car's production lasted for six years until 1994.
try going on ebay!
that is the cooling fan relay.
the alternator is located under the inlet manifold
14.5 gallons AFAIK.
Like any other wheel?
6.5 inches. No screw patters match the protege, you'll have to drill alittle bit.
The only tool that is really needed to remove the distributer cap off of 1994 Mazda Protege is a screwdriver. Using this tool will enable you to loosen the cap, and then you can remove it.
Have your Mazda dealer parts department print out a picture of the relays location for you. They will do this if you ask them.
Behind the engine, under neath the intake manifold.
Email me for the Fuse diagram email@example.com
is under the transmission stick console, heres a web page for mre info. http://www.scribd.com/doc/51604740/Mazda-Protege-Workshop-Manual-1994-1998R-English
There are a few reasons why a 1994 Mazda Protege won't start, but does crank. A couple of reasons could be the air flow sensor or a problem in the fuel lines.
When you remove the caliper, the pads can be pressed out by hand.
aft side of the engine about the center bottom area.
base model and DX have 103 HP. LX model has 125
Under passenger headlight behind front bumper.
It could be the ICM or the pickup module.