answersLogoWhite

0


Best Answer

Sounds like the abs module is toasted or the abs motor relay is stuck closed. Pull the fuse out so you don't run the battery down then take it to a trusted garage for repair.

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why is abs moduler run when key is off?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is the problem with a 2001 Chevy Astro if ABS light suddenly appeared and when van is turned off a motor keeps running forever?

the abs pump needs to be replaced it has a relay that is built into it that defaults to on and will allow the abs pump to continue to run with the key off


Why does air suspension pump run with key off on 2001 navigator?

It will run until the vehicle is level off. Then it should stop.


Does a 1998 Ford Escort have abs brakes?

On a 1998 Ford Escort : It could be equipped with ABS brakes . When you turn the ignition key to the run position , just before starting the engine , see if there is an ABS light that lights up momentarily in the lower left area of your dash ( assuming the bulb is not burned out , or if it is not equipped with ABS brakes )


How do you access the on board diagnostics for a 2002 Jeep Wrangler Rubicon?

well, if it like my 97 turn the key to run ( not start ) 3 times ( off to run, off to run, off to run ) and watch the odometer.


How do you retrieve codes on a 6.7l diesel?

1.) Insert ignition key 2.) Move the key from LOCK TO OFF, THEN PAUSE, 3.) Move ignition key to ON/RUN 4.) Move ignition key BACK TO OFF 5.) Move ignition key to ON/RUN 6.) Move ignition key BACK TO OFF 7.) Move ignition key to ON/RUN and STOP THERE! The THREE MOVEMENTS from OFF to ON/RUN should be done in LESS THAN FIVE (5) SECONDS. You then read the codes where the truck's odometer shows TOTAL MILES, NOT TRIP MILES. (NOTE: FOR EXACT LOCATION OF KEY POSITIONS ON IGNITION REFER TO YOUR OWNERS MANUAL.)


How do you run self diagnostics test on 2001 jeep wrangler se?

Key on, off, on, off, on.


Should the fuel gauge work with the engine off and key in run position?

Yes, key on, engine off, the fuel gauge should work.


How do you program my 97 lincolin mark VIII key fob?

Key Programming -- SpareCycle the ignition switch from OFF to RUN using a programmed key. After the anti-theft indicator goes off, remove the key.Within 15 seconds, insert a new encoded key into the ignition. wait till the anti-theft indicator goes off, turn key to Run/ START


Why does car turn off with key in run position it is ignition problem if you hold key between run and start it will stay running?

Have you tried changing the ignition switch?


How do you program a new transponder key for a Pontiac Montana?

Should work 1999-2006 Pontiac Montana. To create spare key: 1) Place alread programmed key into ignition. Cycle ignition from OFF - ON(RUN) - OFF. 2) Within 15 seconds, insert the new transponder key in the ignition. 3) Turn the key to ON(RUN) or START. 4) The theft "Security" light will go on then off. Turn key to "OFF" position. 5) The key will now start the vehicle.


What causes an engine to shut off when key is turned off?

Electrical circuit is broken. No electricity and the engine will not run.


Can Windows XP work run off a Universal Serial Bus key?

Yes it can !