answersLogoWhite

0

The Volvo design has a pressurized cap on the overflow resevoir. It's rated for presssures of 1.5 kPa for many models, doing the same thing as the metal cap on the typical American brand cars.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do i replace a distributor cap on a 1990 Volvo 740?

To replace the distributor cap on a 1990 Volvo 740, first disconnect the battery to ensure safety. Remove the screws or clips holding the distributor cap in place, then carefully lift it off. Note the position of the ignition wires before disconnecting them from the old cap, and then attach them to the corresponding terminals on the new cap. Finally, secure the new cap in place, reconnect the battery, and start the engine to ensure proper installation.


How do you add coolant on a Volvo s40?

Where is the radiator cap on a 2001 Volvo s40?


Where is the gas cap release lever on a Volvo 740?

To the left of the driver seat on the floor.


Is there a rotor in the distributor on a 1988 Volvo 740 GLE?

Probably - remove distributor cap and look


Where is the radiator cap on a 1999 Volvo S80 Turbo?

There is a white tank up by the passenger's side fender. This is the reservoir for the radiator. Do not remove the cap while the coolant is hot. The radiator itself does not have a cap on it.


Does a Volvo c70 have a radiator cap?

No, the Volvo C70 does not have a traditional radiator cap like many older vehicles. Instead, it uses a sealed cooling system with a pressure cap located on the expansion tank. This design helps maintain pressure and reduces the risk of coolant loss. If you need to check or fill the coolant, you'll do so through the expansion tank rather than a radiator cap.


Where is the radiator cap on Volvo s70?

The radiator cap on a Volvo S70 is located on the top of the radiator itself. To access it, you may need to open the hood and look near the front of the engine bay, typically near the center or slightly to one side. Always ensure the engine is cool before attempting to remove the cap to avoid burns from hot coolant.


How do you take off distributor cap from a 1991 740 volvo?

To remove the distributor cap from a 1991 Volvo 740, first ensure the engine is off and disconnect the negative battery terminal for safety. Then, carefully detach the ignition wires from the cap, noting their original positions for reinstallation. Use a screwdriver to remove the screws or clips securing the distributor cap and gently lift it off the distributor. Be cautious not to disturb the rotor underneath, as it should remain in place.


Location of theromostat in 1990 pont. sunbird le?

under radiator cap


Where is the radiator cap located on 1997 Volvo 850?

It does not have a radiator cap, you fill the radiator through the overflow/ reservoir tank located on the passanger side inner fender. It has marks on the tank to show normal fill levels (about half full is normal).


How do you replace distributor cap wires if i didn't mark it on Volvo 740?

Cylinders are numbered from the front, 1 through 4, and the wires go from top to bottom of cap, 2, 1, 3, 4.


How do you put coolant in radiator on 2003 Volvo s80?

To add coolant to the radiator of a 2003 Volvo S80, first ensure the engine is cool to avoid burns. Open the hood and locate the radiator cap; slowly twist it counterclockwise to relieve any pressure. Remove the cap, then pour the appropriate coolant mixture into the radiator until it reaches the fill neck. Replace the cap securely and check the coolant level in the overflow tank as well, adding more if necessary.