The large current flow used to weld, can overload the electronics on the vehicle.
The battery is located at the rear of the vehicle; in the trunk. You must remove the tire cover, then remove the right side panel and you'll see the battery there.
Remove the seat. You will find the battery under it. Remove the negative terminal first, then the positive terminal.
The battery is on the passenger side of the vehicle, behind a barrier in front of the wheel. You have to remove the wheel and barrier to access the battery.
Disconnect - battery terminal Raise and support vehicle Remove wiring harness from starter Remove mounting bolts Drop starter
Disconnect - battery terminal Raise and support vehicle Disconnect wiring harness at top of starter Remove mounting bolts Remove starter
REMOVAL Turn the ignition switch to the Off position. Be certain that all electrical accessories are turned off. Loosen the battery negative cable terminal clamp pinch-bolt hex nut. Disconnect the battery negative cable terminal clamp from the battery negative terminal post. If necessary, use a battery terminal puller (2) to remove the terminal clamp from the battery post. Loosen the battery positive cable terminal clamp pinch-bolt hex nut. Disconnect the battery positive cable terminal clamp from the battery positive terminal post. If necessary, use a battery terminal puller (2) to remove the terminal clamp from the battery post. Remove the battery cables from the battery. Remove the battery thermal guard (1). Remove the battery hold down bolt (1) and battery hold down (2) from the battery. WARNING: Wear a suitable pair of rubber gloves (not the household type) when removing a battery by hand. Safety glasses should also be worn. If the battery is cracked or leaking, the electrolyte can burn the skin and eyes. Remove the battery from the battery tray.
Remove the Negative (black) battery terminal while the vehicle is running and if the vehicle dies then it's the alternator, if it stays running then it's the battery. Although this method isn't guaranteed it's usually accurate. DO NOT REMOVE THE POSITIVE terminal (red) from the battery while it's running. It could cause a spark and make the battery explode. Another way is to drive to Autozone or Advanced Auto and ask them to test it. They'll do it for free.
Disconnect the - battery terminal Raise and support vehicle if necessary remove wiring from top of starter Remove mounting bolts Remove starter
Jack up left front of vehicle and remove left front tire. Remove left front inner splash guard.remove battery holdown,negative battery terminal and thenpositive terminal.Remove battery through inner fender well and replace with new.reverse order for installation.
Disconnect - battery terminal Raise and support vehicle Loosen and remove mounting bolts Drop starter Remove wiring from top of starter
Disconnect - battery terminal Raise and support vehicle Disconnect wiring at top of starter Remove mounting bolts Remove starter
Disconnect the - battery terminal Raise and support vehicle if needed Disconnect wiring at top of starter Remove mounting bolts Drop starter