0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Which is Fuel pump inlet and outlet?
Inlet line will be bigger then the outlet line. on the contrary on my motorcycle fuel pump, the inlet and outlet are the same size!
Should you run the pool pump with a pool vacuum?
Yes
If a pool has no skimmer where do you put the hose to pick up dirt?
They use to have an adapter that would go from the hose to the inlet side of the pool which in turn went to the pump, most above ground pool use flex hose from the skimmer basket of the pool to the pump, you may just have to put a tee fitting in from the inlet side of the pool and add another inlet just so that you can vacuum, and cap this when you are finished vacuuming, this would be on the outside of the pool this would be added anywhere from the pump back to the pool on the inlet side.
What is a pool vacuum leak?
A pool vacuum leak could mean that there is a leak in the vacuum hose that you use to vac the pool. Or it could mean that there is a leak on the suction side of the pump. It could be located somewhere between the skimmer and the inlet of the pump. At the pump it could mean that there is a leak at the pump seal or the pump lid or a pump gasket. Some of these leaks will not produce water at those leaks they may only suck air into the system. k
How often should ford e350 vacuum pump be changed?
Whe it needs it
Is it ok to reduce the inlet of a pump from 34 to 12 if the hole in the pump's inlet is 38 ID with 34 thread?
Itll work' just not as efficiently
Where is the vacuum pump on 91 s-10?
The engine is the vacuum pump. All the vacuum operated accessories are operated by the vacuum supplied from the engine.
When you run the vacuum cleaner you lose water pressure and it stops what would be the problem?
Usually caused by a vacuum leak on the suction side ,between the pump and the inlet at the pool. Or a blockage in the vacuum head or hose being used for cleaning, such as too many leaves or other foreign object. An over filled filter can also lead to easier loss of pressure , as the pump is already running at near cavitation.
Why does the pump lose its prime when the vacuum is hooked up?
You probably have air leaking through either your vac hose and/or the valve that controls your vac line. You might try replacing the gaskets on your valve stems and try a new vac hose. Also important to get the air pout of the hosing you are using to vac wuth before opening the vac line.AnswerThe pump loosing its vacuum is definitely caused by a poor seal somewhere between the suction of the pump and the suction inlet of your vacuum equipment. In the case of an above ground installation, check all connections of the hose and your vacuum apparatus.In the case of an in ground installation, you could have a crack in the pipes from the pool inlet to the isolation valve close to the pump. To check this, make sure the water level of the pool is ABOVE the connection point where you attach your vacuum hose. Set the filter up for vacuum operation WITHOUT hooking up the vacuum hose. If the pump keeps it's prime, your pipes are probably O.K. Check your vacuum hose and apparatus. If you keep the water level higher than the suction connection in the pool, even if the connection is not 100%, the pump won't loose it's prime.
Which outlet on fuel pump is supply and which one goes to carb?
The pump should have a marking on it in the form of an arrow, "to carb" or "carb", or an "in" & "out" on it near the inlet and outlet ports (normally the bottom but depends on the mfg of the pump).
What controls the vacuum lines in a 93 Honda accord?
The vacuum lines, in a 1993 Honda accord, are controlled by a vacuum pump. The vacuum pump regulates the proper pressure in the vacuum lines.
Where does 1999 dodge ram 2500 get its vacuum?
A gasoline engine makes it's own vacuum. The diesel engine has a vacuum pump next to the power steering pump.A gasoline engine makes it's own vacuum. The diesel engine has a vacuum pump next to the power steering pump.
