Because there is no current flowing in the rotor, and thus there is no magnetic field in the rotor, and thus there is no torque between the rotor and the field.
Any specific device that draws a current which is connected within the circuit is an example of a circuit load. That may be a resistance and a loudspeaker LED computer and induction motor or whatever which can withdraw the energy from the output.
Continuity is checking for a completed circuit including a short circuit. Checking resistance would be checking in ohms resistance of a circuit, motor windings or an open circuit.
In the circuit where the DC motor is added, it was not specified whether the motor was added in series or in parallel to circuit elements. If it was added in series, it will increase circuit resistance and it will cause circuit current to go down. In parallel, the motor will reduce total circuit resistance, and circuit current will increase.
By varying the Resistance to the motor. These Devices are called RHEOSTAT'S
baaa boom
rotor contactor are used to cut the resistance in slip-ring motor connected through resistance box. resistance is proportional to torque. so by controlling rotor contactor resistance can be controlled and hence torque can be controlled. for more information check torque and speed characteristic of wound motor.
What supplies a dc motor is not current, but voltage. Current is what flows in the circuit formed by the dc motor and for the charge. That current varies according to the resistance of the circuit.
Wound-Rotor
because at start the motor draws larger quantity of current and this may affected the rotor windings in order to limit current always resistance is connected.
it means that it's star connected on the motor part
because at start the motor draws larger quantity of current and this may affected the rotor windings in order to limit current always resistance is connected.
A motor in a circuit is classed as the circuit's load.