answersLogoWhite

0


Best Answer

because your an idiot

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why won't a 1985 Toyota pickup stay running?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

The charge and brake lights on 1986 Toyota pickup stay on?

Replace Alternator


1996 Toyota Camry will start but wont stay running on its own?

Check the idle sensor if you have one.


Why won't my 1985 Pontiac 6000 start?

have a pontiac 6000 2.5 motor and it wont stay running


Why does it stay on in my Toyota Sienna?

WHY does WHAT stay on?


Why does the 4wd light stay on a 92 Toyota pickup 4wd?

Because your in 4 wheel drive mode? Switch and or linkage out of adjustment. Bad switch. Bad Relay. Grounded circuit.


Should a 91 Toyota Corolla always have fuel pressure?

If engine is running then the answer is yes. And pressure will stay in the fuel line for some time after you shut the engine.


What are some possible causes of a Nissan standard 5 speed pickup starting but will not stay running or go into gear?

Chect the slave cylinder on the fire wall to see if it is out of brake fluid.


When was Stay Hard created?

Stay Hard was created in 1985.


What needs to be replaced in a 1985 Pontiac Firebird if the car only stays running while foot is on gas and the throttle positioning sensor had been replaced?

it might be because the idle is low turn your idle up and it should stay running


Why a 1990 Toyota Tercel 4 dr hatchback wont stay running it will start but then bog out after 1 second?

Check fuel pump pressure Possible bad fuel pump


What could be the problem with a 97 Dodge pickup that start and die will not stay running?

could be the fuel pump not working. when you go to start the truck just turn the key on and go to the gas tank and listen if you can hear the fuel pump running. should sound like a whining sound.


How do you reset the circuits of a 92 Toyota pickup 2wd so the check engine light will turn off?

Disconnect the negative battery cable for a couple of minutes, then reconnect. This will clear the error codes from the computer. If everything is okay, the light will stay off.