0
Why won't driver's side door lock work with switch or keyless entry Will work only manually What could be the problem?
Wiki User
∙ 14y ago
Most likely the switch on your driver door panel needs replacing(ebay!). Or if you or someone you trust has a multimeter(electricians tool) you can check the existing switch. You must first remove the switch from your panel. Hope this helps and I hope your switches are'nt clustered(all together).
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
If a red security light just came on in a 2000 Oldsmobile Intrigue could it be a keyless entry system problem?
It is possible that the door jamb switch is weak. Starting with the drivers door, wiggle the switch and then close the door; if this helps to shut off the light ,replace the switch.
How to manually shut the sunroof?
There is most likely a yellow switch in the trunck on the left side (drivers side) to switch from auto to manual
I have a 1990 Ford F150 with a 5spd M5 trans. New reverse light switch that works when you manually activate it but does not work with it installed in the transmission what is the problem?
sounds like a problem with the grounding on switch
How does a passenger window stop in the down mode and all other windows work properly what could be the problem?
Replace the switch ! It is really not that expensive and it will fix the problem !! If it works from the drivers door replace the switch on the door that doesn't work ! If it works at that door replace the drivers switch ! KM
What would cause the power lock switch and the key to not unlock the doors of a 2001 Venture but the remote keyless entry does work?
The first and cheepest thing to check is the fuses. located on the side of the dash by the passengers door, another is under the hood on top of the battery. The next would be lock switch.It is easily installed, no tools needed. The drivers side power switch is a master switch. This means that power feeds from the drivers lock switch to the passenger door. If your key fob will unlock and lock the doors but the switch will not I would replace the drivers door lock switch.
How can you manually close a power window?
You cannot manually close a power window. You must repair the problem causing it not to work. Check the fuse, power window switch, and if they are good, you may need a new motor.
What is a keyless lamp holder?
A lamp holder that turns on from a wall light switch not a switch on the device.
What is the problem if passenger windows can only be opened by the switch on drivers panel and drivers window does not work at all?
Sounds like a defective switch on the driver's door disconnected wires on either door or you have a lock out switch turned on... with driver door, i suggest pulling your "panel" off and verify your switch is actually connected and if it is, then replace the switch
Why won't 94 crown Victoria drivers window will do nothing It will not go up or down cannot raise it manually?
Check to see if you are getting power to the window motor- if so motor is bad If not check switch and wiring to same. Common problem is an open wire in the door hinge area
Can you insure a car in Florida if you have a residence there and NJ drivers license?
Depends. If you're in the military it's not a problem, but if you're a civilian you must switch over your drivers license.
What can cause the power locks not to work on a 1990 bronco?
I replaced the drivers door switch on mine and it took care of the problem
Why are the lights flashing on my 1993 Jeep Grand Cherokee limited?
I had the same problem with my 1997 Grand Cherokee and it was the dash mounted automatic light switch. The problem was also solved by turning the headlamps on manually.
