answersLogoWhite

0


Best Answer

Remove the air cleaner housing or at least lift it up and prop it.Clean the carburetor linkage especially the choke!!!!!. Use carb cleaner(I prefer brake cleaner more thoro) and then lube ALL the linkage with liquid wrench or bp blaster (wd 40 is NO good) and this will correct the problem!These carbs are notorious for sticking choke linkage I know first hand after owning mine since new for 22 yrs.

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why won't my Mazda B2200 won't kick down out of fast idle?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What are timing specs for 89 Mazda b2200?

Stock ignition timing at idle is 6 deg BTDC +/- 1 deg. I like to set mine for about 7 or 8 deg BTDC. Kyrasis6 Mazdatruckin.com


Your 1986 Mazda b2000 runs fine but will not idle any suggestions have new carb plugs cap rotor fuel pump?

I have an 89 Mazda b2200 and all i did was mess with the timing and it started to run better,a but a friend suggested that I pull the distributor shaft and turn it a notch.


Mazda 626 throttles up and down at an idle and while driving?

throttle postioning sensor is bad


What is causing the high idle sound when you start your car?

Cars often idle fast when you start them up. The automatic choke will make the car idles fast for a while then the idle speed will slow down, once the engine warms up.


Where can I find a Mazda millenia idle speed sensor?

The Mazda Millennia Speed sensor tells the speedometer how fast the vehicle is traveling. Speed sensors are located on top of the transmission housing where they can reach the input shaft. The speed at which the input shaft spins tells the vehicle how fast it is moving.


Where is fast idle solenoid on 3.4 Monte Carlo?

there is no "fast idle solenoid" there has'nt been a fast idle adjustment on passenger cars in over 20 years


How do you fix the idle on a 1992 Mazda 929?

To adjust the idle on Mazda 929 from 1992-1995.......on the top side off throttle body there is a idle air screw,turn screw cloclwise to reduce RPM. Question...is idle always high when hot or cold?


2003 Mazda staling it run good but when i idle at a store for a while and try to good fast it start jerking but i restart it and it runs .but if idle again same old stroy. please help?

im sorry but your store is so last year!!!


91 Mazda b2200 cnannot increase engine speed above idle even with accelerator all the way to the floorhas 175k just showed up after gradual loss of power?

Did you check the cable that runs from the pedal to the intake? Maybe it could be broken or just simply worn out.


Why would your 1995 Chevrolet Monte Carlo idle real fast and then real slow rev up and slow down?

A vacuum leak or a dirty or defective Idle Air Control Valve will cause an unstable idle. jd


How to idle down 1993 Chevy truck?

That engine is computer controlled therefore the idle was preset / calibrated from the factory and there is NO adjustment. You need to have the engine scaned with an engine scanner to see what is making it Idle to fast. Check for vacuum leaks first.


Your 1993 Lincoln Town Car Idles at fast idle and will not come off of fast idle anything you can fix yourself?

*